How to install sprockets on enviolo hubs

How to install sprockets on enviolo hubs.

00:04 - For this, you need the following tools:
Small flat screwdriver.
Optional for Gates sprockets; the Surefit assembly tool.

00:08 - Clamp the wheel in a vice with the left-side axle flats.

00:13 - The flat sprockets 17 teeth and bigger assemble with the sprocket first, followed by the 2mm spacer and secured with the snap-ring.

00:28 - The 16 teeth sprocket comes with two 1mm spacers, place 1 spacer below the sprocket and 1 spacer on top, then secure it with the snap-ring.

00:43 - The Gates sprocket assembly is the easiest when using the Gates surefit assembly tool.

00:49 - If done without the tool, wiggle the sprocket on by hand, make sure it is fully seated and secure it with the snap ring.

00:56 - Place the sprocket onto the hub, place the tool over the sprocket with the arms situated in the gaps and hit it firmly to make sure it is fully seated. secure it with the snap-ring.

[cimmaycimmay]

I'm happy to see the snap ring can be removed and installed with a screwdriver.

[saib]

Hello with the gates sprocket, you don t need spacers?thx

[marmadave]

With the Gates sprocket fitted, should there be any play/end float? My sprocket can move ~1mm side to side.