Stuck Caliper Guide Pin??? Easy Fix. Full video on my channel. #shorts #youtubeshorts

[brianheath]

That guide pin was not stuck. There was resistance, but there’s a big difference.

[tomthackston]

Take it apart clean it with brake cleaner and they make a brake hone for that too. Then some fresh grease and your good to go.

[ronheil]

Thank you for getting straight to the point. This video really helped.

[jasonconrad]

If you got 1 seized:
Leave on vehicle & remove boot etc.
Torch casting & slide until slightly glowing at outer mating place.
Let cool 1 minute then air hammer backside of slide.
Replace slide & reassemble.

[MrThorMNFinest]

The problem here is the grease got too far to the bottom creating a hydraulic lock. Sort of like chinese handcuffs. So when u pull the pin it creates vacuum pressure. Too much grease. Just clean it all out w brake cleaner wipe old grease away and lightly coat the guide pin w any multi purpose synthetic or silicon grease. You can use white lithium just try not to get it all over the rubber boot. Remember : silicone feeds rubber. Others eat rubber over time.

[WilliamVG]

Definitely need to take that apart and clean it.

[papabits]

Wire wheel the pin to remove the old dried grease, take a bore brush and clean the bore with brake cleaner. Then you can re-grease and install.

[John-tvid]

Your video saved me some money. I was going to buy new parts.thank you😊

[jjshow]

Thanks bro. That’s what I was looking for. Only my inside pads were wearing

[JamesZ-pyxl]

I had one that got stuck in the rear brakes and it caused my pads the wear at an angle. The culprit was the boot ripped and let dirt in and tore the little rubber sleeve on the end of the pin and it melted

[podnolej]

Clean bore boot and pin use die electrical grease on pins it will move freely.

[jameslewis]

I just put an impact with a 17mm socket on it and spin it till its loose n free then pull it out

[unitedwestanddividedwefall]

Can you clean them out? Like spray brake clean the hole and regrease the pin?

[blacktactical]

silicone grease? Or should we prefer dielectric grease for caliper pins? I would be happy if you help

[eddfranco]

My wear only driver side this is the razón thanks

[earnestcoleman]

but when that goes bad what is it do, as far as does it make noise when you press the brakes?

[bigfist]

I just put new ones in for the few quid

[Noorrahman]

Does this cause vehicle jerks at certain speed?? My car jerks on 30 speed.. feels like something is holding the brakes

[mrrjtrevino]

What was the problem they were haveing

[AaronBilger]

had some get so rusted in place that they broke trying to free it up