How to fix E1 error on a treadmill. Also known as Error 01 or LS1 low speed error

in this video we show you how to fix speed error E1 or LS1 or E01 on a treadmill.
This is a common error and is also known as speed sensor error or motor error.

[oilpressing]

Yep the magnet was out, thank you very much😁

[makdeniz]

How much lubricant is too much? I’ve used half a bottle and I still get the E1 message on my treadmill.

[Palocles]

So you’re saying that if the control board is stuffed there’s nothing to do? Because you made no elaboration on that at all. Replace it?

[JassiNijjar-xz]

I have the E1 error in my elliptical. Once I plug it in, the display comes on normally, but after about 10 seconds the E1 error shows up and I can’t do anything after that. Any suggestions?

[MarijkevanGyen]

Thanks for the information. My York Zenith treadmill cuts out after 15 mins or so and you said..."theres a fair chance that your motor is stuffed, possibly your controller....that's a bit of a hard one to tell". I'm sad 😕 that you didn't say how we can sort this problem out - or is my treadmill done and dusted??! Do I need to get a new motor? A new controller? How do I tell which one is bung? Do I need an expert to test them out?? Any additional info would be gratefully received. Thanks. 👍

[eugene]

Thank you very much for your assistance.

[MrShaneBryson]

Cheers mate, speed sensor cable was unplugged 😂

[vladimerputin]

The treadmill works fine. Recently it cuts out immediately when it goes over 4kmh it works fine and does bot stop under 4kmh any ideas what it is magnet is ok ?

[dydxequalsslope]

Hi, thanks for the video. My treadmill sometimes starts right away, sometimes it struggles to start with a rattling sound coming from transformer, control board area and error code E1 follows. I tried all the options still the problem persists. Sometimes the treadmill will run perfect with all functions. I recorded that sound. If there is the option of sending the recording I will do that. Thank you.

[christiankaharian]

My Time sport threadmill is giving a E1 error. Sometimes it runs 20+ minutes then the error will pop up. Then burnt smell always coming out at 20+ minutes before the E1 pops up. I already put oil/lubricant in it. But right now. When starting the E1 pops up right away and a "tick" sounds came up before the error show.

[YUVALSERLIN]

Hi
Thank for the video,
I'm having the 3rd option but also it sudenly running faster than the shown speed
what can it be than?

[marscic]

Hi i have an E1 on a jkexer tredmill we just fixed the motherboard and the error it came up again and first i get the belt with of 8/10 aec and then i get the no belt starting..what can it be please

[JassiNijjar-xz]

I have the E1 error in my elliptical. Once I plug it in, the display comes on normally, but after about 10 seconds the E1 error shows up and I can’t do anything after that. Any suggestions?