Yamaha Ignition Relay Stop Switch | G16 | G19 | G22 | G29 Drive Golf Cart

DIY Golf Cart shows how simple it is to replace the Yamaha G16, G19, G22, and G29 "The Drive" ignition relay stop switch. This small part works with your accelerator on your gas golf cart. A faulty switch will result in your cart not performing. Please subscribe to our You Tube channel for other popular videos showing the installation of parts and accessories for golf carts.

[murraymacneill]

I would love to see a video on the full wiring or re-wiring of an older Yamaha gas cart. Maybe a G16 or so. Thanx.

[jessepearce]

Did you say that this stop switch is what grounds the engine out, and will cause it not to SPARK?

[plvsoundman]

I had a problem with my 2011 Yamaha gas cart. Thought it solenoid or battery. Battery was old anyway 5-6 yrs. New Battery, helped some. But after checking. Found it highly possible the gas petal solenoid switch was hanging up and not kicking in on the solenoid . Before I spend $$ on switch I removed and rolled back the rubber boot and sprayed blaster and worked the switch for about 10 times. While I was working on that I also adjusted the gas cable there at the petal about 2 rounds. To give a little quicker response when pressing the petal. Tightened it up and replaced the stop switch. Everything at this point seems to be running much better. If the switch starts to hesitate again, I'll purchase a new one at that time.

[christopherd]

Hi. I’m looking for some help. I just hooked up battery tending cables on my mother in laws 2019 Yamaha EFI so she would just have to plug into it when she leaves for the summer. I did it last year and no problem. Someone removed them six months ago and it’s been running fine the entire time. We used it all week. After I installed them last night we left and drove back to Boston. She called me on the way home and it won’t move in forward or reverse. There is power to the battery because the horn and all of the lights are working. Any idea what could be going on? Ty

[RoosterMclaren]

I have a 2002 G22a gas burner that will not shutdown when I lock the brake pedal down. If the engine is cold it will eventually lope along and shutdown. If it’s warm I have to pull the spark plug or hold down the brake pedal and pump the accelerator until it floods out (I guess). I have changed every part out i can think. A trouble shooting video would be cool. Thanks in advance.

[zackmorehouse]

My engine did this once but no more. I had intermittent pedal clicks the solenoid but doesn’t go. Then a few pumps it’s go. No power leaving the solenoid so is that the issue or volt regulator or stop relay. Does the stop relay only tell the engine that stop?

[carlosruiz]

I have an inline fuse that has blown twice and I'm not sure why it does that, but nothing works when it does, any idea why that would be? It's in the cover box with the solenoid and regulator.

[timknowlton]

I have a 2012 Yamaha Modle YDRAX3 PTV I'm getting fault code 45 which I believe is for a stuck VM Relay. Where is this relay located?

[jasonagema]

I have a 2000 Yamaha g16a. Most of the time runs and start right up. Then other times it just rolls over and wont start. Its getting gas. Just isnt getting spark. What would be doing that. Celenoid clicks and so does the engine stop switch.

[wasillastacker]

I got a 2001 fuel injected Yamaha golf cart that will not turn over the battery is good the pedal switch is good the starter is good the belt is good I can get the starter to turn jump in the solenoid but it will not start any clue what to look for next.

[jessepearce]

My G29 has no spark, any advice? I'm fixing it myself

[Allison]

hello, could you help me I have a yamaha g29 cart the problem it has is that it starts but it doesn't go very far and it turns off completely and until I press the circuit breaker it starts again but it does the same thing and I can't find what it is could you help me

[johngraff]

My 2001 G16 will not suck the air to make the fuel pump suck the gas out of the tank, any ideas?

[scottburns]

Ive got a 1996 Yamaha g16 and the cart just quit while driving. No power what so ever. Ive checked wires and battery. Any help would be great!!

[roberteisler]

Trying to install ignition switch that has no plug?
Can u advise? Supply plug?

[MrGuitarfool]

Thank you for the nice videos ! I have a 1982 yanaha gas golf cart ...it doesn't seem to spin the belt I replace the fuel pump but that is it ! It is a centrifical clutch so how does it make the belt to the transfer case grab !

[russhines]

Yamaha YDAK. Sometimes it cranks just fine when you hit the pedal. Then all of a sudden it does nothing when you hit the pedal. All connections are good, battery is good, grounds good.. Interment problem. What next?

[michaelunangst]

I have a Yamaha 1999 G16E, someone had there hands on it, before I got it, It seems to go faster in reverse than foward, could it be the wires were reversed on the forward / reverse switch, or on the motor?

[tedh]

I have an EZ go that keeps running the start motor sometimes. Not all of the time but just now and then. I'll pull up to my garage and the gas engine stops but the electric stater/alt keeps going. I believe it has drained the battery also. Ive had to recharge the battery from dead twice now. Any thoughts?

[andrew]

1st of all, thank you for your videos as they have helped me tremendously.
2nd I have a G29 gas cart that will intermittently turn over. Sometimes you have to hit the pedal a few times or hold it down before the starter engages. After getting it started and going for a ride the battery would die fairly quickly. I just put in a new battery and it still hesitates to start and sometimes won't until I come back another time and try it again. I've checked the ground at the battery and they are good. Any ideas what my problem could be?
3rd Thank you for your time and again for your videos.