How To Fit Rear Parking Sensors | Easy Installation | Ford Fiesta

In this video I go through, step by step, how to fit rear parking sensors to a Ford Fiesta 2014.
The sensor kit I am using is X-Vision.
The process is the same for most Fiestas but slightly different for other models.

If you found this useful, Please Like and Subscribe.

Comment below for any video suggestions.

[videopud]

Brilliant tutorial. Far better than the Dolphin one where you couldn’t see a thing.

[MartinSmith-pvzf]

Many thank's ive been thinking of doing this job on my v70 for the last 3 years, since i sold my range rover i got used to the lazy convenience of parking sensors, you make it look easy enough for a sunday morning job, thank you again all the best to you

[Martin-wzie]

Found out that if you take off bumper it already has the markings so you just need to make pilot holes then hole saw from out side of the bumper to stop any paint chipping

[maxp]

Quick tip: instead of stripping the wire and soldering, simply use a quick splice wire connector or a T-tap wire connector.
Piece of cake - takes a few seconds, looks neat, easy to disconnect, cheap - no wonder some parking sensor kits contain one of these.

[todotvstreaming]

Is this an aftermarket kit? Did it affect any of your assistance sensors like blind spot or cross traffic warning?

[meriadeglecadre]

On the black trim, better to drill at 80mm instead of 30mm. That will fit like the oem sensors, and as written in one comment, it can be seen on the back of the absorber.
On my 2009 EU Fiesta, the reverse wire is the full blue, took me some tries to find it so here is a tip for the viewers.
Thanks for this nice and helpful video 👍🏻 though.

[philgoncalves]

Hi, I'd love to know what that recess drill bit is called please.
I've tried looking up the above but no joy!

Thanks

[fusion_x_frost]

Hey mate, I have the same version. What drill bit did you use? Can you link it. Thanks :)

[lemanlifestyle]

I just bought an original set from a Fiesta ST in my color from eBay. Drilled 29 mm and plugged the sensors in the socket that’s already behind all the Fiesta bumpers haha. Fixed it in forscan and tadaa. Original PDC on the screen and through the speakers

[FernandoSilva_]

great job! what's name the first driil?

[adambenson]

Does that speaker connect to your car speakers? If not do u know how you would?

[elizabethowers]

What did you unplug? We can't find those cables underneath the lining.

[allianceofvengeance]

Hey can you do this with a 2022+ Ford Maverick? I never knew it didn't come with the truck except for the Lariat models -__- wasted money on the XTL Luxury package thinking it would come with it.

[stavrosdlk]

Can I connect reverse camera in the same cable?

[richardl]

How did you pass the cables through the inside of the bumper and through the panel inside the boot?

[sosnorwich]

Hi. Good video, thanks. What is the name of the ridge cutter bit you're using to recess the sensors?

[escfxp]

Where did you get the drill bits from?

[sneakzi]

Hey Ewan, great video! Is there a way to add sensors and also have it so you get a visual display on the small screen?

[ansamedia]

Since you're only tapping into the reverse power wire, realistically these can be installed on any car right?

[smokeyjoe]

You say you have fitted loads working at ford, however, My 2018 car has canbus wiring, could you advise me whether you can connect the power from the reversing light wiring as you have shown with no issues