Programming and using a Lenz Ls 150 with a z21

On this Video I show how to program the Lenz LS-150 Accessory Decoder using the Roco z21. I also share my adventure in making a point motor work, sharing my ideas how I could make this work with an existing control panel using relays. Hope you find this useful! All the best Tony.

items used purchased through ebay.

Bistable/Latching DPDT 2A Power Relay Module 12v - 20v
Seller: modellingelectronics

2 way relay board , 12vdc operation
Seller: bjelectronics001

And of course some Diodes: 1N4001

Music used:
Believer - Silent Partner - Youtube Audio Library
Caballero - - Youtube Audio Library
Procession - Geographer - Youtube Audio Library
Where I am From - Topher Mohr and Alex Elena - Youtube Audio Library
Licensed under Creative Commons: By Attribution 3.0 License

[Wickford_N_Gauge]

Greetings Scarborough and hello Tony 👋 Another great "Old School" modelling video 👏👏👏 It definitely shows you can have your DCC control cake 🎂 and still eat it using a manual control panel 😎 Excellent resource and very clearly explained 🌞 Very best wishes from County Wicklow ☘

[wimbletrain]

Hi Tony, very well thought out, might have to watch it over to digest it all! This is something I would like to do with my layout but being modular may have to go about it a different way. John

[Hal-Zuzzu_Model_Railway]

Some fantastic outside of the box ideas as always :)
I love it when people take matters into their own hands and not buy off the shelf items :)
Well done Tony!!

[exehavenharbour]

Crikey, I think I understand it Tony, I shall come back to this at a later date to re-watch. Always interesting and informative, cheers for now, John

[Chris-BognorRegis]

Hi Tony, apologies but I have a question about wiring, but not related to this video.
I have been kindly given some Peco point levers and I can find nothing in all my Peco pamphlets that show me how these work or how to wire them up.
Basically I have a PL-50 Turnout Switch Module, a PL-51 Turnout Switch Module Add-on and finally the four PL-23 Single Pole Changeover Switches (On/On) that came with them.
All I want to do is operate four Peco Large Radius points with these.
On the back of the box containing the PL-51 there is a diagram, but I am as thick as pig poo and it means nothing to me. For instance the two wires that go into the side of end PL-51 are yellow and blue, what are they and where on earth do they go to?. I did say I was thick.
Can you please advise?
Regards Chris