Fixing The Polaris High Speed Gear Problem

Josh explains common issues with the Polaris UTV transmissions and how CryoHeat can prevent these issues from happening if treated.

To purchase the high speed gear shim, visit the link below:

Subscribe to the channel for more updates and information on the next CryoHeat project.

For more information, visit our website and follow us on social media!

[scottausmus]

Can I send my transmission to you to repair? 2015 Polaris ranger 900 seems to jump out of gear or miss a tooth at high speed

[joemartinez]

How much for one of ur transmissions, mine blew right side bearing and housing

[dn]

I have a noise between acceleration and deceleration which sounds like play in the trans. After seeing this video I have an idea this might be related to this problem? Would it sound like “crunching” when letting off the accelerator if the high speed gear had movement from side to side from a bad snap ring?

[marcleblanc]

Looks cool, not my problem, I hope.... the hi was difficult to engage, often grinding on half position till pushed. Now the low left engagement, so ajusted the rods, but the hi seems on low speed.... didnt push it yet.

[andrewz]

Will this shim work in a 2017 Polaris XP 1000 EPS?

[danielgarvin]

Ate the dogs off the high gear last summer, rebuilt the transmission and added the cryo heat shim. One year later, no high range again.

[armedfarm]

I see way too many people using a heavy gear oil in these splash lubricated transaxles.
So it's too thick to splash around in the case these parts wear out, esp. the side load shaft bearings & thrust washers & snap rings that hold them together. Use nothing heavier than a 5w-20 or JD hy-gard low -vis, or AGL. No more 80-90, or 75-90. 75w would be ok, remember oil in splash systems has to be thin like most all trans/diff/axels.

[riotwarrior]

Hey. I just blew hi gear and feel it's same issue as shown here...can you tell me more about this shim you have?

[clodnut]

I wanted to buy that shim, but it's not listed on your site

[wicked.mainah]

Would this cause the transmission to make a clunk on take off in high gear only?

[ritchie]

What does it sound like when this is happening?

[jsimm]

Just put your foot on the brake and stop before you yank it into high gear . All you need to know .
You can also grind the dog catches right back too .

[ME-pbgf]

What a crock. Now you will just shove the bearing into and possibly through whatever pocket it's sitting in.