PMOS & NMOS Inverter

preview_player
Показать описание
PMOS & NMOS Inverter
Lecture By: Ms. Gowthami Swarna, Tutorials Point India Private Limited
Рекомендации по теме
Комментарии
Автор

Use coupon "YOUTUBE12" to get FLAT 12% OFF

TutorialsPoint_
Автор

Mam one request, you should take a side for a second from the board after explaining so we can take screenshot of the board.

gajendrasonare
Автор

It seems to me that zero voltage is not going to make any sense here as the PMOS is in the off state gets zero volt in the gate terminal and it turns on when the the gate voltage is the low voltage here most probably means the negative voltage in stead of being i right mam??

tamimshikto
Автор

madam in pmos transistor, Output is taken near to the ground, whatever may be the input, the output is always connected to ground, so output is zero . clarify my doubt

epurichiranjeevi
Автор

TEAM TUTORIALS POINT YOU GUYS ARE DOING GREAT WORK.

akashj
Автор

thnku mam aaj aapse sikh liya monday ko meri exam hai

sagarmahavar
Автор

Mem you are the Best I really really now word to show my Gratitude Thank's

AshishCE-ir
Автор

PMOS and NMOS inverters well explained. Thank you !

agstechnicalsupport
Автор

In pmos the output is connect to gnd then it will 0 in both case. because at for 0 input pmos is on and vcc is connect to and so how current go to output.

priyeshmalviya
Автор

I don't know why I'm hearing ma'am-cute or it's sir-cute 😜😂
Great teacher
#respect

emproduction
Автор

Mem the truth table of n mos is same with p mos.how two currents going at a time .if u clear my concept .i will thankkfull to u.

iftikharkhan
Автор

Y pmos is good for passing zero or low.

mohammadadil
Автор

India carries my whole university. Wished from germany yes yes

spicedude
Автор

Pmos inverter doesn't make sense in that diagram without a resistor

benbabu
Автор

Lectures are simple and accurate.
Well a little bit of accent work would lit up your lectures.
Thanks!

manomohandas
Автор

my pmos is getting cut and my pmos is getting high voltage then i get zero warts with high voltage to my pmos.... is this sex or mabe im sooo lost 5min to 5min50sec is section of tutorial that lost me..

davidbahr
Автор

Mam, shouldn’t NMOS always react on high-voltage then, when we put (1) then shouldn’t we get output 1 too?

happiness_creators
Автор

What happen when nmos is connected to pull up network

VijayKumar-cnqn
Автор

Thank you so much for your lecture mam 😊

keerthanakondapalli
Автор

Dear madam, If you are taking output of pmos from the terminal connected to ground then it will always be zero

vishnuharidas