E3D Revo™ PRUSA Mini+ Upgrade Guide

Показать описание

Revo Micro is a great fit for your Prusa Mini+, with no firmware changes required to complete the upgrade. Simply mount Revo Micro using your printed part, rewire your Heater and Thermistor and then recalibrate your z-offset.

Рекомендации по теме

Комментарии

Tip: Put some cloth on your heatbed to not scratch the surface by accident.

ulaB

Can you explain what's behind the name Revo? Hemera and Titan both had a meaning behind there name, does Revo also have one?

seha

I am getting poor print quality on all three of my Mini's with a Micro. Anywhere there is low volumetric volume it seems to over-extrude and ooze a bit. Have yet to be able to solve the issue.

AronsTube

was there some sort of re-development on this? Because I bought a Revo for my Mini+ some time ago and it doesn't look anything like this?

JohnWeland

does the revo micro come with the extension cables that go all the way to the board?

aoife

Just got one and installed it when I went to turn on my printer I got a thermistor warning. Hopefully it just needs to be seated better…..

arudd

Can the mount be printed in PLA or does it have to be PETG or ASA?

BenHardingVideos

What voltage version is used for the MINI?

spartan

Is it the same for the revo six? Your link in description is revo six not marco

cyrillee

Hey there! In my Revo Micro I didn’t have a color clip but instead a plastic nut. What should I do?

alanallen

Can we cut out the connectors and solder the extension directly?

rcobsesssed

Does the new hotend perform better than stock?

terrellma

Can you do please this for the Anycubic I 3 Mega. I've been wanting to put the revo system on my anycubic I3 Mega for so long, but it's always different or the same printers (Creality, Prusa printers) that are shown in video clips. please help me with this as I am not a techie in this.

markleppens