Stihl Carburetor Rebuild - Stihl 036

Stihl Carburetor Rebuild on a Stihl 036 Chainsaw. My Stihl Chainsaw was "waffling" when in the cut so I put a new gasket kit on the carburetor. Druing the Stihl Carburetor Rebuild I put a new air filter, spark plug and fuel filter on the saw. She is running like a champ now!

[JeffLieurance]

Nice job..Clear, basic, and informative instruction.

[ddddddddddddddddd]

Wow !  An informative presentation without a dull commentary and dorky music. Thanks.

[ultimateormus]

The level on the float lever is what I needed to see., 👍

[farawayland]

I also have a Stihl 036 which I have used for 20 years now. The only thing I have changed is the spark plugs. So far my 036 runs perfect. But I will go back to this video the day I have to clean up the carburator and change fuelline. Bad no new screws followed with the new air filter.

[Kaloboos]

You should bring up idle a bit. Recommended value from stihl is 2500rpm for this model.

[miguelmarrero]

muy buen video donde podemos pedir el aparato para regulas las revoluciones del motor gracias

[beebob]

Would have liked an explanation of what you were doing. But the work part was good

[service]

Sometimes, you can spend a few dollars more for a complete carburetor compared to a rebuild kit. A lot of times fuel and air passages are almost impossible to clear. Many repair shops now days do replace then clean and rebuild.

[destincoble]

You should invest in some non-chip acrylic top coat nail polish to seal those welch plugs. Carburetor cleaner sometimes can be too harsh of a solvent, try using non-flammable break parts cleaner instead to clean surfaces and to spray the high and low speed.

[dslag]

Anyone know what the metering lever setting is for the Walbro car on these MS2590s? Just rebuilt mine and discovered on the Walbro website that part number 500-13 is needed to set it properly. At 6:34, a straight edge is used in the video but no actual measurement/setting is indicated.

[sonofthunder.]

found it thanks, I have a major on my 034 super

[davidlis]

Great video but I believe it would be a lot better if your were talking and explaining what you are doing.
My 2 cents

[yancyreed]

saved a 34 super from my uncls dumpster . went through saw good compression every thing ok, started it up adjusted a bit but it just keeps running away on me I can keep it calm if I work choke with my thumb but the second I don't it tries to rap out ? sucking air ? or carb problem ?

[charithrawijayasiri]

sir can you tell the name of the scanner that you used to tune the mchine

[perry]

You did not remove the adjuster screws and blow them out.

[gmac]

What is with the ruler while tightening the needle valve?

[FishFind]

Wow just like it was brand new! Looks great I want to find an older 0 type model not the ms and see if I can spruce it up and get it working since those where the best saws they made. But then I think will I really bother fixing it

[samjisdasss]

How to avoid piston scoring. What is the contribution of carburator to piston scoring, piston damage, please replay me sir.

[BackwoodsEXPatriot]

Great detailed video!  Did you end up milling at all last weekend?  Weather was bad here, and continues to be.

[dougbalduini]

My Pro 036 is bogging down. Not sure if I have to replace or rebuild Carb