Edgebanding curved Corners by Hand

In this short video tutorial I will share my trade secrets on how to edgeband your manufactured board products where you have curved corners. This can be quite tricky to achieve nice clean and tight joints between your PVC edging and the edges of your board. With a few simple but effective steps you too can get perfect professional results.

Video Links:

EDGE MELAMINE | The Best 3 Ways to Edge & Trim Your Board At Home!

How To Edgeband & Trim Melamine | Edging Melamine Board | How To Apply Edgebanding Pro Tips

Affiliate Links:

End Trimming Tool:

Chamfer Tool:

Planner Blade:

Vacuum Pump (NOTE: NOT THE SAME PUMP AS I PURCHASED BUT SIMILAR! - check the pump has your countries power-point plug):

Pneumatic Foot Pedal:

High Strength Spray Adhesive:

Contact Adhesive:

Heat Gun:

Flush Trim Router Bit Set:

Recording Equipment (Please note I am NOT Sponsored by these brands in any way):
Rode Wireless Go II:

Rode Lavalier Go Professional Mic:

Sony ZV-E10 Digital Camera & Vlogger Kit:

[rickstid-bits]

Geoff. Thank you for posting this video. I am making shelves in the shape of a "U" for my pantry. They each have 2 inside corners and 2 outside corners. I could not find any help anywhere on how to trim the corners of the edge banding. You have the ONLY help online with how to trim the corners. I used the jointer blade you suggested and my corners turned out beautifully! Thank you for posting this! Rick

[antoinettefarrugia]

Wow, it turned out pretty good but then again everything you do turns out good and neatly done! Good vidio

[Gazman]

I really like the use of the edge planer blade for trimming. I've never seen that done before. Seems like the perfect way to do it after watching you do it. Your skill in placing the blade to trim the banding is notably experienced. Well done, and thanks for the tutorial. Happy to subscribe.

[anthonybowyer]

Hi Geoff; great video as always, greetings from the UK. Is there any chance of some more cabinet building guides? I have learnt so much from you're channel, anything on bedroom furniture would be of great interest. Thanks again.

[shotgunsean]

What is the compressor for? At first I thought it had something to do with you securing the workpiece to your bench, but I’m unsure. I’ve never seen a compressor like that. I’m curious what you’re using it for here.

[g.fortin]

i can guestimate but wondering if you could say the min radius this will work well for ? what you have tested.

[olegx.]

Thanks for sharing your knowledge. I wonder if such 90 degree curved angles can be covered with 2 or 3 mm veneer? Or it's too thick?

[nickgalena]

Hello, which Filter do you use on your vakkuum pump ? - searching for a suitable one.

[孙悦-rl]

This kind of work efficiency is too slow. Now there are curve edge banding machines on the market. A plate can be finished in three seconds. Why not choose curve edge banding machines and edge trimming machines?

[GS-kbvy]

That compressor noise .. so .. distractive