xTool D1 Pro 20 watt- The Ultimate Step by Step Guide

In this video I will take you through the step by step process of assembling your new xTool D1 Pro laser including the unboxing, using the free Create Space software, and making a small item. I was very impressed by how fast this 20 watt diode laser cut and would compare it to a co2 laser. If you haven't purchase an xTool laser yet, I would really appreciate you using my including links. This really helps support my channel. Thanks!
Save $80 with code- xToolMaki
xTool F1 Ultra

xTool P2

xTool S1

xTool F1

xTool M1 Ultra

#xtool #xtoollasermachine #laserbusiness #metallasercuttingmachine #laserengraving #jewelrymaker #xToolF1Ultra #lasermachine #lasercutter #metalsmith #businesslaser #metalengraving

License code: GRKYXEWTRYWNOEMF

Air Assist affiliate links-

[chaddiy]

USE promo code xToolMaki for $80 off for orders over $999
Air Assist affiliate links-

[mfkhometheater]

Great Video! I bought the 20 watt along with the extensions probably 7 or 8 months ago, still haven't gotten around to getting it going. I did finally put it together about three months ago. I'm going to try to get it running next week. Your video makes it look pretty easy!

[noahsark]

Thanks for the video. I have one of these units. Question please. Is there any way to repeat a laser process if you move the laser head out of the way to inspect what you just lasered? Can you set it back again to the precise spot? I see the x and y numbers on the screen but they don’t seem to change when I move the laser head aside. I was hoping I could write those numbers down and then move the head around until the numbers match up again and then engrave a second time if needed. I use creative space too. Thanks.

[robr]

So I have a couple of questions about using this how easy is it to figure out as far as where to put the product your working on for example to left middle top bottom etc and also for example doing one item vs 5 also it is harder to small items such as dog tags on this I'm asking about this because I saw a video where a big project shifted because it was going to fast thanks

[dougward]

Thanks for the video. Just got my D1 pro yesterday. Set up was easy but making things looks daunting. I assume it is all trial and error as far as getting the settings you need? Use scrap wood until you are ready?

[finney]

Hey man, I bought the same one. Though, the Xtool software does not look like this. This layout here looks much better.
Is this the older version?

[jacobbates]

Lightburn is badass. I don't think it's complicated

[postiesteve]

assembly video great - software part not so needs narration to explain what your doing, not music