BendPak 4 Post Lift HD-9XW - Build,Tips, Tricks

HD-9XW BendPak 4 Post Lift and our experience.

[StevenHill-lg]

That short hydraulic line messed me up so bad thanks so much for the video you saved me large. I couldnt figure that out. Thank

[shenanott]

Thanks for the heads up on the flex line. I just did mine yesterday and I noticed that the flex was too long then I remembered your tips and tricks video I had watched a couple of weeks ago . Try doing it by yourself...

[rickhoward]

This week installing the bendpak hd973p triple stacker i ran into the same problem with the flex hose. First time intalling Bendpak as we almost always deal with challenger or Rotary. I ended up eliminating it and using sheath instead since there was no information on it otherwise, especially with the triple stacker .Wish i would have found this video sooner

[JP-ecfe]

Literally just 20 minutes ago I had the same experience with the flex hose and hydraulic hose. I was able to find a supplement online where bendpak talks about cutting it to length but nowhere in the instructions does it say to do that.

[awidesigns]

great video, only thing i would add is sounds like you are not level or something not in sync. During the test lift the locks are not hitting at same time. They should all snap in about the exact same time.

[wickedweyandfroends]

Any chance u could show the hydraulic motor a little better

[mikezurawski]

Is there a specific kind of teflon tape for the elbows of the feed and return lines of the hydraulic ram? That stupid flex hose drove me crazy!

[JP-ecfe]

Sorry if I skipped over any of this, but:

Is that a 110v motor instead of 220 like the spec sheet says for that lift?

Did you set the runways on their narrow setting or wide? If setting on the wide, do drip trays and the jacks still work?

[rogfromthegarage]

I wonder what happens when someone who doesn't weld gets a broken part? Seems like a major pain.

[myreadinglife]

Is there any support for the rod end of the cylinder when extended ?