Multilayer Switching in Packet Tracer 6.1

Please subscribe!

[andersonmyguy]

I usually don't comment on these kinds of videos, because I just watch them to understand my university classes.
But this video deserves a comment! It was the smoothest tutorial I have ever followed on Cisco Packet Tracer.

Thank you for such a great video!

[danscourses]

One thing I wish I could redo in this video is at one point I use the: ip default-gateway <ipaddress> command, but since it a layer 3 switch with ip routing enabled, I should have created a default route: ip route 0.0.0.0 0.0.0.0 <exit interface or next hop ip address>

[josueochoa]

Omg I just needed the No switch port command to assign an ip!! Thanks 🙏

[lordythegreat]

couldnt believe how easy that was one command and you remove the need for a router-on-a-stick setup lol. thanks for the video!

[mylegend]

Thank you Dan for showing it in very easy way ..really appreciate your efforts.

[guillaume]

You'r my savior !
I'm on 6.1.1 SV, i'm a biginner*

I built a little network (90hosts), with 4vlans, without serv. 
No ping, i searched a lot !! And now, ALL works !

thx dude*

[Haidarsattar]

Best videos I watch so far, on more easier, all videos. God bless you

[mahtalabbafi]

Thank you....all of your tutorials are perfect!

[tsonnguyen]

I have a question. For example there is a another VLAN, let say VLAN30. Is it possible to configure that only VLAN 10 and 20 can ping each other. But 10 and 30 cannot ping each other, the same with 20 and 30.
Sorry for my bad English. Thank you for your time !!!

[richardking]

Thanks for the help understanding Layer 3.

[eyeagura]

Hi, Thank you so much I've been looking this tutorial for many days. you helped me a lot thank you so much for solving my problem! You're amazing man.

[yhytuncer]

you are a great instructor Dan ! Thank you

[drdre]

That was clear and very detailed, thanks.

[ralalka]

thank you so much this was very helpful

did not know that you can change the switchport into a router port
problem solved
thanks again

[mkormike]

Does it matter the router used? I’ve used 2811 with fast Ethernet instead of gigabytes ports and it’s not working

[Alianger]

Can you use the same ip address for all virtual interfaces?

[keeran]

Hi Dan, in this example you are using a 1941 router as the isp, where you can configure a static route to the layer 3 switch. What if you are using physical devices and using ISP modem? Can you please shed some light on this? thanks

[alfredogranja]

Man you just saved me, i had configured it all and nothing worked. The only thing that i was missing was the command ip routing on the multilayer switch

[krampenaflor]

Hi dan i have been watching your videos its easy to understand unlike other instructor online. One question, since you make the directly connected ip as ISP sample in this lab i think default route from s1 towards the router is not necessary because the switch already have it on its routing table as its directly connected

[abdullahalamoudi]

Good, We need the same lab with channel-group on two port directly to the router and two switches