how to weld hollow iron corners for gate frames #weldingshorts

[dennisatherton]

Just keep grinding til the undercut dissapears lol

[trinidyjohnson]

Best tacker this side of the Mississippi

[Insomniac_]

the comments for these videos are the best part...

[billpickelheimer]

Should start from the inside corner and go out so it stays square and does not draw from the weld heat, spot welding is not good and you took most of the strength away grinding the cold weld away

[PaytonConway-fw]

Bro quit spot welding. Tack it on there then do one very clean consistent weld. This weld eventually will break off using this method.

[SmokeyG]

Why not just use mig or tig at a low heat low speed feed or use 7010 instead of 6018 and not tack weld everything

[xl]

I don't really weld, and I know that this is not how you're supposed to do it.

[normanyoung]

Must be eligible the jointed edges to give a deeper weld. I suggest you take some welding lesson. Commented by retired welding inspector of some 44 yeears

[sergico]

Царапать металл ни в коем случае нельзя! Зачищать до гладкого можно лепестковыми шлифовальными кругами! После окрашивания место стыка должно выглядеть как литое. И если уж совсем придираться, то шов на профильной трубе желательно чтобы был на одной скрытой стороне. Я обычно так лестницы делаю.)

[SFCDonkey]

Reduce that heat and actually run a bead

[nicholassoviak]

Yeah the other side has a 1/4 in gap and can take a clamp and tap through what he grinds off doesn't even look good

[nathanielt.]

The welding besides, as you could do that a couple different ways, broski, you gotta gring that better... you're gonna see those grinder marks from a mile away. Grind flat and straight in the same direction

[dplzinn]

Se fosse um disco flep teria um acabamento muito melhor

[tunamanusmc]

Way wrong and you can see the perosity. Just weld it normal

[Jamoliddin_Umar.]

У профильный трубы есть лицо и задняя стенка. Такто заебись

[Zzw]

Isn't that how you weld any thin metal

[supac]

Now you’re just a good grinder, not a good welder!

[lienly]

bạn không cần bỏ lớp vỏ .tôi cũng biết mối hàn của bạn trông như thế nào và những điểm nào có bọt khí .nói thật nhé, bạn chưa đủ kĩ thuật để hướng dẫn

[juliancarrillo]

Asi no se ase asi esta grajil solo se tiene que aser todo seguido ain despegarlo

[ПетрХ-гэ]

Именно так у нас зачистили стелаж, почемуто он сложился