Adjusting settings on Anthem MRX 1140 after a reset - Home Theater #28

****TIMESTAMPS BELOW****
In this video, I go over the settings I change on my Anthem MRX 1140, wether it is the first time or if I had to reset it.

00:42 Factory reset Anthem MRX1140
01:17 Checking the IP address
02:00 Creating the inputs
02:34 Adding new inputs
02:58 Input settings: Name
03:07 Input settings: Video & audio
03:26 Input settings: Speaker profile
03:41 Input settings: Mode presets
04:06 Input settings: Anthem room correction
04:14 Input settings: Dolby post processing
04:42 Input settings: Lip sync
04:49 Input settings: Input trim
05:05 General settings
05:27 General settings: Max volume
05:41 General settings: Power-on volume
05:53 General settings: Power-on input
06:11 General settings: No signal power off
06:23 General settings: Front panel brightness
06:30 General settings: CEC settings
06:47 General settings: Closing thoughts

Music by Vegetable Police at:

About Random Distractions
I'm a busy husband and father of two that not only works full time but I'm also building up a photography business. However, I have distractions that take me away from that and this channel is all about that. Join me to see if you enjoy games, technology, and other random things.

Please consider subscribing

[RandomDistractionsYT]

These are just a few settings that I update, are there any others that you use that come in handy?

[mikewright]

Watching these closely my new one should arrive Monday.

[Foxhound]

How can I make primary input each time I turn on the mrx1140, for example it’s set to PS5 each time i turn it on, I like my primary input to be my nvidea shield, is there way to change this, thank you

[Roots]

Hey off topic but what ever happened to the Monkey Strength updates? Those were really good and I liked comparing against how others are doing since I just started the program!

[robo]

I just purchased a MRX 1140 and experienced something very similar. Even to the point I received a note that said, “Speaker distance measurement failed: The following subwoofer distance exceeded the maximum supported by the target. ARCG will switch to relative delays.” When I finally completed the process, my distances were very wonky…one sub at 0 feet other all other speakers at 30 feet. I will definitely go back re-perform after analyzing my Left Front speak SPL and then attempting match or exceed by 2-3db. Quick question, on the back of the subwoofers, are dials set to 80Hz or 120Hz? I am not sure where to have mine set. Thanks in advance!

[dsm_]

When I turn it on the volume is always way too high. Do you know how can I change this ?

[njrumenos]

Don’t listen to James Andersen he doesn’t know much he’s still learning