Provent 200 install in a Landcruiser 200 Series

Step by step installation of the Provent 200 into a 2020 Toyota Landcruiser 200 Series

[noelomeara]

I just had mine done at a 4x4 workshop. When I picked it up I was concerned because the supply hose went under the radiator hose, crimping it almost flat. I had another look at your video and I can see how you have it going above the radiator hose. I think I will go outside and change it to the way you have done it. I also share Paul Barry's concern about oil build up in lower sections of hose. I suppose I will need to periodically remove the hose and flush clean.

[kerrymulcahy]

I mounted mine next to the brake reservoir and the after market fuel filter on a bracket, the same side as the hose comes out of the engine without all the extra hose around the engine bay.

[paulbarry]

Nice vid.Mine was done similar by a workshop.The hoses on mine run behind the fan area, and if you look at your vid at 8.12, you will see a couple of threaded holes, middle of pic, a saddle for one hose was fitted there, then other hose cable tied to it as all well away from the fan.Then run down behind air box same as yours.Was concerned oil may log in trap of either hose, as they go down then up, but maybe enough flow so this doesnt happen?Some seem to run across rear of engine which keeps hoses up higher and they can drain either way, back to engine or can.

[Mark_vids]

Is it critical if the catch can is not 100% level when installed?

[petersmith]

Great vid, what model is this catch can and we’re can I purchase it please
Thank you 🙏🏼

[justinstewart]

excellent video! - were you really doing this at midnight with a headtorch!? lol

[hunter]

Thanks for the video, where did you use 16mm - 19mm elbow?

[leighgranland]

I ask the dealer about it they reckon not to fit one to my new gx they might not warrant the motor

[saadalharbi]

Thanks for the vid, can you please send me the link for this catch can

[aaroncuthbert]

Why would you move the horn if installing catch can? Irrelevant