061 - I2C communication example: OLED Screen Introduction, Setup and Display using code from scratch

Welcome to the WeeW - Stack

Welcome to this new video for the STM32F1 microcontroller, where the code is from scratch.

This is the part of the tutorial where we use the I2C communication knowledge we gathered in the previous video setup communication, initialize and display on the OLED screen (SSD1301 Driver):

This tutorial is divided to 8 steps and the topic will be as bellow:

1- Introduction to OLED Screen

2- OLED Addresses & Types

3- OLED I2C Communication

4- Setup oled_cmd_1byte() / oled_cmd_2byte()

5- Setup oled_init()

6- Setup oled_data()

7- Display "Hello WeeW "

8- Bonus

Next Video:

Pre-required tutorials:

[abhinavlal]

Thank you very much for the video. I learned a lot from it.
Please continue to make such videos.

[rajeshkumbhakar]

Thank you for your videos, I am sure you can put your videos in udemy or somewhere but thanks for keeping it free :)

[ManhNam-BDCVTNguyen]

hey, why u use 0xA1 and 0xC8 instead of 0x00 and 0xC0

[fausaancm]

A little warning. You can't change the IIC address on the Ali Express model by resoldering the resistor as shown in this. I've tried it and didn't work for mine.

[farukca]

Hi Weew..Thank you for your videos.These are so instructive..Can you make a video about SD CARD viewer on OLED (like a file manager, text, jpg, mp3 etc.) because there is no video for STM32F1 with keil..