REVIEW Powerfix Profi + Multi-Function Detector 5 in 1 (Lidl construction conversions renovation)

Amazon:

REVIEW Powerfix Profi + Multi-Function Detector 5 in 1 Z31174 (Lidl construction conversions renovation)

Facebook:

Manual:

Multi-Function Detector
IAN: 73382

Features:
Versatile tool for house construction, conversions, renovation work, etc.
5-in-1 function:
Ultrasound distance measurement (approx. 0.6 - 16.0m) with area and volume calculator
Wooden foundation detection up to a depth of approx. 38mm
Electric cable detection up to a depth of approx. 35mm
Metal detection up to a depth of approx. 24mm
Built-in marking laser up to 10-metre range including spirit level for aligning tiles, suspended cupboards, etc.
Measuring unit switch (m/ft)
Large, clear LCD display with light
Memory saves the last measurements
Includes 1 x 9V battery + instructions
5 in 1
Laser safety classification: 2
Marking laser

[caras.marius]

Hei. You don't get the distance to your hand right because minimum distance to measure is 0.6m.

[jimsim]

The detection of hidden objects is the same in all
three modi (STUD, AC WIRE, METAL).
Please note: Test the device before initial use
on a metal pipe or AC wire whose position you
know exactly.
1. Slide the function switch 9 to the position
„DETECTOR“.
2. Slide the material switch 3 to the position
STUD, AC WIRE or METAL (wood, AC wire
or metal).
3. Calibrate the multi-purpose detector by holding it flat at the desired point on the wall.
4. Then press and hold the PUSH button 14
until the signal ends. The display 2 is turned
on. The appliance is now adjusted to the wall
thickness. Continue holding the PUSH button.
5. Move the appliance slowly over the wall
surface. When you are getting near to the
object you are looking for, when the arrow at
the point in the display begins to move. If all
the arrows appear in the display and the
signal note sounds, then you should mark this
position (see Fig. D).
6. Repeat this process on the other side of the
wall. As soon as the signal sounds, mark this
position

[jimsim]

Slide the function switch 9 to the position
„DISTANCE“. The display 2 is turned on.
2. Hold the appliance horizontally to the wall at
the distance you wish to measure. The ultrasonic - transmitter / receiver 16 must point at
the wall at a right angle. Use the vial to do
this 8 : direct the appliance so that the air
bubble in the vial lies between the two marker
lines.
3. Press the READ button 6 . The measured
distance appears in the display.
Note: Hold down the READ button and move
the appliance and move the appliance further
over the surface to be measured. The appliance measures the distance continuously.
These are displayed in the display

[dant.]

When measuring, the length of the device is also taken into account, otherwise you cannot measure the distance between two walls!
And that is not a laser pointer, it is an laser leveler, working together with the bubble from the device.

[jimsim]

it is a ultrasonic detector. your hand is to soft use it against a hard surface, remember the measurement starts from the back of the unit not the front, and the laser is only an indictor as to were your measuring to and from. But hay thank you for taking the time to up load.

[vreijs]

Did you check the manual? Distances lower than 60cm can not be measured. Also don't measure it on an angle (see also the manual). Detector has to be pendendicular to the wall.

[miltfrangos]

Someone has obviously never read the manual.

[samgosnay]

Get to know your product before you do a review