How to Relocate a Fuel Tank | Kevin Tetz with LMC Truck

Learn how to relocate a fuel tank from the cab to under the bed of your truck. Kevin Tetz reviews the parts you need for this type of project, including sending units, fuel caps, and inline fuel pump kits. Then he walks you through the steps to move and install the gas tank between your truck's frame rails.

[AlbertoVillaRomero]

Loved this video, he makes it look so easy

[victoroneill]

For a perfect ground use conductive grease (not Dielectric) on the contact surfaces because it will prevent rust.

[TheAbaker]

Great video. I was trying to put the mounting tabs between the channel and for the life of me couldn't figure out why it wouldn't fit.

[michaelknight]

Gettin the hole in the bed right is the tough part I imagine

[nativestacker]

LMC Truck, how about a tank relocation kit for 1988-1998 Chevy trucks, from side saddle to center rear .( where factory spare tire is located ) . I realize the cross member would need to be removed and a new set of cross members installed near the rear and near the axle to make room for the tank .

[markekberg]

What about if you want a duel tank set up with one in cab? How low does this tank hang down below bumper?

[TruckThisGarage]

So how can I keep water from collecting on top of the tank and possibly leaking inside.

[ethanmiller]

With this sending unit make 60 psi or will I have to buy a aftermarket one?

[jeffvw]

I so wish you'd do a vid on installing the side tank. I want to leave the spare tire where it is.

[chrisvercher]

Do you have this video for a 65 f100 Short bed? Just went to Lenexa in KC today at your LMC Ford Warehous and picked up my tank. No instructions

[ronstickle]

hi Kevin. Glad to find you again on LMC i wish i worked with you!

[DaRealArtist]

Do you have a video of routing the steel fuel lines and hoses along with a inline fuel filter?

[invisableobserver]

Does LMC have a tank that I can add an internal electric fuel pump in tank? and sending unit with 2 openings for EFI?

[jerrygarcia]

showing the the installation of the straps would have been helpful as well as the anti-squeak kit. Does the Tank need to be level? The frame on the 66 Ford F-100 is not., at the location where the tank fits it has a slight arch in the frame..

[arnulfoesparza]

How do I find were to cut the hole on the bed ?

[LuisTorres-otib]

Very informative
Can you make some more videos about 88-98 Silverado??

[Showmangreengo]

Hi guys when are you having top fill tank back in stock?

[isaaccarranza]

I had a question i have a 72 c10 n I relocated the gas tank i have the original fuel pump but the gas reaches the carburetor n only fills the filter a little bit n when all the gas goes it it turns the truck turns off idk if i need the same fuel pump like yours with the steel lines n the the one lines that comes form the tank

[chrisdimitrijevic]

thanks for the video, would that tank work for a 55 second series truck (55-57) Thanks in advance

[jackdaniels]

You say it’s so easy to put in, but… the bed has to come off. It would be great to have a video that shows the real world of replacing/relocating it. Otherwise, this was an excellent video. Thanks for showing it.