How to Assemble a Kegerator

Assembling your kegerator may seem complicated, but it can really be completed in just a few steps. By taking the time to make sure your kegerator is properly set up, you can count on serving perfect beers to patrons in no time!

After moving your unit to its final location, install the draft towel by placing a rubber washer on the top, feeding the beer line through the opening, and placing the draft tower on top of the opening. Secure the tower with 4 mounting screws, and feed the air hose into the draft tower from inside the cabinet. Screw the tap handle onto the tap faucet, and install the CO2 tank by attaching the beer line to the keg coupler. Attach the gas line to the CO2 regulator output barb, and tighten the screw clamp. Connect the other end of the gas line to the keg coupler and tighten the screw clamp, and then attach the CO2 regulator to the CO2 tank. Screw the coupler onto the keg, and when fitting into place, push the coupler handle down to open the seal. Open the air tank, switch the shut off valve to on, and adjust the PSI to between 10 and 15. Carefully place the CO2 tank into the cabinet and close the door, and your kegerator is ready for dispensing!