Bricklaying - How To cavity Tray your corners ✅

#shorts #best #construction #funny #new #satisfying #tips #tricks #bricklaying #fast

[richardrobinson]

😂😂😂 look at the state of that brickwork

[beakofthesouth]

Lovely and tidy on the tray which you won't see.. and absolute carnage on the face work...

[carlbolger]

I want to see one where they clean up the mess they leave behind.

[bradwhelan]

That brickwork must have been laid during a thunderstorm in the dark!

[jessebenware]

Tape and a staple . The Egyptians don't even compare 😂

[phillipmetcalf]

takes the time to tape the corner then staples above the tape. great water proofing

[daveworzel]

The dpc looks neater than the brickwork.

[BigLeo]

Why don't you extend the tape up onto the corner so it seals it also? A staple on a folded corner is just a future leak isn't it?

[richard]

No bricklayer on site would ever do this. They don’t even take time to lay the bricks properly or point properly and defo tidy the brick face properly 😂😂

[alanwarren]

Nice tidy job 👍🏻👌🏼how did you do the internal one ? Haven’t seen a video on this

[sharons]

It's amazing to watch skills like this!! I wish i'd chosen a different job to do when I was younger. I think I'm better at working with my hands than working in an office!

[jameswaby]

😂😂 yeh how many times have I seen this on site 😮 never

[ABW]

I’m no brickie but that mortar work is shocking

[carrot]

Someone should show you how to build brick work

[britishpakstar]

Well done first time I seen this being done looking professional I like a good trade man who take pride in the work

[rondickinson]

Why not fold the top down to shed any water? Would it obstruct something?

[michaelmclaughlin]

There’s nothing more in impressive than someone who knows what they’re doing !

[chrisg]

Forgot a very important step forgot to fill the holes in the brick the water will run right in them holes

[darylhill]

That’s actually very helpful thank you looks like the guys who did the footing didn’t mind working in the rain 😂

[nathd]

What about the flat bit? No seal on that? What is the point of putting weep holes if it passes through that unsealed cross joint to down below dpc?