GLIMPSE of FREE ENERGY OVERUNITY ROTOR SPEED UP

A regauging magnet is placed back behind the motor coil to speed the rotor up and I show that when it is removed and the generator is applied that I can get a temporary near 277% efficiency effect.

However there's a problem with current going up with the regauging magnet as it should be going down. There are several factors affecting this such as rotor speed in RPMS, core saturation, regauging magnet distance from core and strength, etc.

I'm not sure what it is in this case, as I've sped up rotors before to tremendous speeds with current draw cut in half, so I am still trouble shooting this thing. It could need more voltage to raise the RPMs enough to get the effect.

[Theminecraftian]

With the magnet on the back, my first thought was that the magnet on the coil was slowing down the flow and putting more drag on it in half of the coil, so it had to push more energy through, the higher energy throughput going through the un-impeded part of the coil would be pushing the motor faster. But when you talked about you having it done before and the current being cut in half, that's what got me thinking. So when you did it before with the copper coated welding rod, was it the same diameter as the ferrite rods or were there many more sort of bunched up? I think that the amount of rods in there could change the effect on the current. The copper coating could have something to do with it as well, so perhaps you could get a sort of copper pipe that could fit inside the coil to test that. You could put the ferrite rods inside the copper pipe to see if you get the same effect as with the welding rods.
To further test that, you could put the copper coated welding rods in the pipe and see how that effects it.

This is all just speculation on what might do what, so none of what I have said has been founded by experience, but only by logic and progressive thinking.

[paulocubo]

what if you use Electro-Permanent magnet and putting on the back? you can switch the polarity of the Electro-Permanent magnet

[anonymous-usxb]

Why don't people take an engine turbo (which is made to "move" fluid - like water, air is considered a fluid), put a pulley on it's shaft, connect pulley to a generator, put turbo inline with household water supply; everytime anyone uses water it will turn turbo/generator and supply power to charge batteries for an inverter. Free power.