My FiTech settings: Fitech Tuning Tips

When I installed my fitech and was trying to learn it, I wish I had a walk through of someone’s settings I could copy. So that’s what I’m going to do for you today.

**NOTE: If you buy a FiTech from Amazon, buy it from FITech, not a third party or FiTech will not be under warranty if something goes wrong**

Here are some of my favorite tools:

Join the Nashville Early Bronco Community on Patreon:

Thanks for watching and be sure to SUBSCRIBE so you'll have more Early Bronco video's in your inbox!

[tays]

Most of these videos have convinced me to just stay with my holley 4160 and mechanical pump in my foxbody.

[davidreid]

This is the best video i have watched. My Fi-Tech was doing great, THEN it got where it would NOT crank without priming it, may still not, It was also running a tad rough, I followed some of your advice and car is running best it has. It does have a dead spot on acceleration, so i got to watch a video on that. My car is a 1970 396/402 with eldebrock intake. Any suggested watching i'd be grateful, main issue not cranking without a prime of a touch of gas poured in. Hopefully we ironed that out, i'll see after it cools down.

[jndesign]

Thanks for all the fitech videos! Very helpful, would not have been able to get my car running as quick as I did without them!

[highguys]

Thanks for posting this, I've had no luck with the customer service at fitech, but your videos have helped me with my own fitech project.

[teamplayer]

Why does Fitech not have an entire library of tuning and setup videos/articles? Part of a good product is documentation and not leaving the customer to just figure it out.

[Rush-gzsx]

If youre not using a FCC then you should change you fuel pump PWM to max value (on all the time), ESPECIALLY if youre using a Walbro 255 pump. You are currently using PWM according to your settings in the clip.

[Amilzera]

Fitech uncomplicated and simple, for V8 the best I've seen so far.

[itiswatitis]

My fitech was back firing and idling almost tuning off i used all these settings in the video except cid mine is 350 and and i have a cam so i set it at 2 so far no more back firing

[michaelbritton]

IF you put the Engine CID to 303 then submit it...turn key off wait for dashboard to blank out then turn key back on it will stay at 302

[wheelmanvicful]

I'm installing my fi tech soon cant wait

[scottsinfl]

That should help some folks with settings. Great vid.

[dannyporter]

having trouble with my fitech it just cuts off like you turned the key off.any help would be great

[corygraves]

I just installed the ultimate fitech on my 49 chevy pick up. It starts but its running full rich and will not idle. I have tried adjusting with no change.

[AsgeirSaem]

Nice video. Fitech is on the buy list. So I will use that playlist ; )

[classicman]

Does thes settings apply for 2x4 setup

[johnnymcclurg]

Thanks for the video man if I am in any more trouble how would I be able to get ahold of you seem like you got this thing down

[mikeburnett]

I have a 400hp FiTech on my car, but it doesn’t decelerate as fast as a carburetor. How do I adjust it to decel faster? Hope you can help

[philh]

So what are the symptoms of incorrect sensitivity rpm? Extended crank??

[lowhombre]

Super video, thanks again for doing this. I learn so much every time I watch your video. I wish Fitech has a cheat sheet for number wise and also I heard some people are doing firmware upgrades on their controller, you heard of such a thing?

[monstermustang]

I didn't know about the temperature setpoint for learning