How to install a Grab Bar in a Bathroom. #diy

[AngelVilla]

I won’t install hand rails unless I know I can grab a stud or a horizontal 2X4-2X6 mounted beforehand during rough-in for bracing. Especially for commercial use, I just can’t trust them plastic anchors for support. Really cool tile drill bit though. Need to check those out

[dougpeters]

Nice job. I have that Milwaukee mini hole saw, its great for tile.

[snubby]

Spraying water helps reduce cracking as well

[nicopolis]

Put white 100 percent silicone caulk over screws and under rings .

[joshnolastname]

Get someblue bosch glass bits, they work really well for this. I save the dimond bits for the hard stuff

[Cfomodz]

Homie you go to the ends of the earth to not crack the tile while drilling and then use a Hammer instead of a $3 mallet to push in the anchors?! 😅

[ironfistvail]

You should put some glue on them anchors and put silicone on the back side of the bracket

[artgarcia]

Good job on not damaging the tiles but that grab bar won't hold the weight of the person using it.

[themagicman]

diamond drill bits are only really necessary to drill into porcelain.

[tonygoshive]

Good job apart from not siliconing thr holes

[jeffreyhenderson]

Ummm, how are you waterproofing those holes, sir?

[Vincenzooh]

Saying you go for the diamond bit- and then giving a reason based on the type of drill you are using does not make any sense. No mater what bit you use in a hammer drill it could cause damage to the tile. Hammer should not be in the name of the drill you use for tile lol

[Anonymous-iqkc]

Obviously, you don't want to use a hammer so close to your tile.

[elsensei]

How about next time you use the hammer to break the tile, then you dont have to worry about breaking it.😂🎉 Jk

[kuriouslee]

PLASTIC ANCHORS for handicap grab bar ???