Interfacing NEMA 23 | NEMA 17 | NEMA 34 with TB6600 stepper motor driver

In this video I will be showing you how to connect any stepper motor requiring maximum 4 amps of current to a driver and Arduino. We will be using TB6600 stepper motor driver and a 12volt power supply. You can use these motors and drivers with some more modification in a 3d printer, cnc machines etc

Project and video by Pawandeepsingh Dhingra
No paid promotions unless stated

[atulkhatavkar]

How to control multiple stepper motors with same driver I want to move 6 28byj motors with one arduino

[leonardorodriguez]

How come you don't connect the ground of the Arduino?... and still works.

[frankdoyal]

Do you have diy dtg driver kit for some of the Epson printers?

[arkhanjamedar]

This driver is TB6600HG with 4.5A max output, where TB6600 is of 3.5A - 4A max output, For NEMA 23 3N-m which is high torque in its class, this mention driver in video is good.

[feyisetanbenjamin]

I am just stock . My stepper motor isn't just moving (not rotating).

[isettech]

Video could have been more comprehensive to include setting the current required by the different motors. Leaving the default could be too high for the smaller NEMA 17 motors and too low for the NEMA 34. A comment on the voltage and step rate could be included in the next video. 12 Volts limits the step rates. Most 3D printer use 12 Volts. Table top engravers and smaller lasers use 24V. Larger devices with faster step rates often use 36, 48, or higher, but that would require a different stepper driver that can handle the higher voltage.

[uniqueobr]

How to connect couple of tb6600 drivers on arduino, do I need to stuck couple of 1pin cables in one hole or?

[mohammadsantosochannel]

hello, I want to ask, how to add torque to the Nema 23 stepper motor, Nema 23 Servo C2 2 Phase 3A Stepper Motor 1.8 Unipolar Bipolar, with the tb6600 driver

[Mots-mot]

whats the maximum RPM u can get by this driver + Nema 23 + Arduino ? i am not able to get more than 200 rpm . please suggest.

[Любительтехники-ъи]

Good evening! Can you show the wiring diagram of the inputs and outputs from the arduino board?

[matheusschumacher]

im trying to use nema 17 bipolar stepper motor with this code using all correctly configurations but still its just shaking and not spinning and yes im using a TB6600 too

[electronicsideas]

I have a problem when I open stepper motor shaft out and fit again It won't work properly

[visionaryrobotics]

Great video, I was wondering if I can adjust the amount of volts and amps that comes out of the power supply if not do they make power supplies that have adjustable volt and amp output.

[sziluchannel]

Hello at 3:02 there is a hole in the middle of the motor shaft. Is that a screw hole or what is that?

[hichamlachguer]

Nice tutorial
Do you have idea to control AC motors single and 3 phase

[RLcncservice]

Without Arduino broad running motor???

[boostbyarus]

is there any heat problem with the driver?

[abdullahansari]

Hey mate,
I want to run a two motor at a time sapouse the 1st rpm is 5 and other one is running on 7 rpm at a same time

[zazee]

How to add ON/OFF push button in this code .??

[jefrinjohnson]

How much volt is required for nema 23 23kg and for TB6600