How To Install Your Schlage F Series Handleset (F60/F62/F93)

[romanmoretti]

Thanks for making this video. I found it very helpful when I switched the lever.

[Ladybrite]

Very helpful for me. I am replacing Schlage for Schlage so I didn't have to do any drilling or hole making. The hardware was very easy to work with and your video helped to make sure I was placing everything right. Now I have a beautiful new and working like a dream front door handleset. Thank you sooo much.

[aimedegrenier.]

What a great instructional video for installing a lock on a standard pre-cut door. Thank you!

[Rogue]

Thanks for this video. I spent a lot of time staring at the instructions like a neanderthal, then watched this and was done 5 minutes later.

[thetexanist]

Seriously?!? Ads on the official Schlage channel!!!!?! WTH?!?!

[JonnoPlays]

I think I installed my handle wrong. The inside lever turns up to open the door instead of turning down. I can't seem to figure out how to correct my mistake. Can you suggest anything to help me? Thanks so much

[martymarr]

Very good instructional video. Thank you for providing

[jaxchristian]

Wasting time trying to change the back set. Watching this video hope it helps.

[GKNP]

I dont have a hole at the bottom for my door handle. How do I do that?

[asouegirly]

Just bought a Schlage Latitude Keyed Entry Door Handle/Deadbolt Combo. The locks on both handle and deadbolt only lock with key in cylinder and then cannot remove key. Does not seem right at all.

[jimkay]

Install was easy but the inside door lever is loose, it wobbles. Is there any way to adjust it?

[Jeezuzisreal]

The video shows only a right swing door. My handle is a left. I tryed to reverse the handle for the swing of my door but no luck. I have to lift the handle for right swing door. this video was sent to me by Schlage does not cover this.

[fattymcboom]

This is terrible. Sure it talks about the 'handing' of the lever on the inside of the door, but it doesn't show that you cannot depress the lever downward when using this setup. All of the handlesets are for left open doors, so you have to PULL UP on the lever. It also doesn't show that the lever moves when you depress the pull handle button. Thanks for nothing.

[dmann]

What do you do if when you press the outside thumb lever and it is hard to push because it is also moving the inside lever?

[suechanger]

Locked my front door deadbolt last night and now it will not unlock. The inside lever moves but the door remains locked. how can i remedy this?

[randssperl]

My latch would not turn far enough or release. Turns out I needed to pull the inside latch double "hole" horizontally (away from the latch itself).

[Jonathan-pxoz]

Is the 'SUPPORT PLATE' an optional part of the faceplate? The depth of the router for my faceplate is only 1/16" deep and I do not wish to chisel it out. (In other words, can I simply remove it as I would for the drive-in faceplate option, but then put the regular faceplate back on, minus the support plate?)

[jaxchristian]

Omfg still doesn't show how to switch the backset

[dontblameme]

I would like more details on her handing techniques.

[jaxchristian]

Wasted 7 mins never showed how to switch the backset