Communicate siemens S7 300 PLC with Sinamics G120x VFD Drive via profibus using TIA Portal Part#1?

#g120 #plc #vfd
Download Full Project from this link

Please Subscribe to Easy PLC Tutorials for more Videos and Tutorials

How to communicate siemens S7 300 PLC with Micromaster 440 VFD via profibus using Simatic Manager ?

How to communicate siemens S7 300 PLC with Danfoss VFD via profibus using TIA Portal ?

Siemens TIA PORTAL Complete Tutorial series for Beginners

[yveso]

Thank you very much, was looking for this because we're replacing MM440 to G120 on Profibus.

[mirzamansoor]

Thanks for uploading this type of Videos.

[mughal]

Thanks a lot. We are going to replace old Siemens MM to SINAMICS G120. I was looking such video,

[a_sava]

Thanks for sharing this. You saved me a lot of time.

[muhammadshehbaz]

amazing video, really helpfull for engineers. keep making videos.

[umarafzal]

its very help full thank you soo much
sir please can you tell theirs only one perameter p918 we need to set on drive side and after that our plc to drive communication is done.?

[kiranchoudhari]

Good information 👍😊 brother I understood 💯

[maximjones]

How you determined the hexes command for Cotrol ON/OFF = 047E and other commands? Where is the its sources?

[iqbalmehedi]

nice video.
please make SCADA for this motor control.

[maheshbhilare]

Thanks for vedio.... Make one vedio on how to tak wincc flexible running back-up with its Recipe... I have tried ... But not able to restore it's old recipe

[engmohamedrefaat]

Thanks for your efforts need video about communicate s7 1200 with abb acs 550 or acs 580

[mohdirshadshaikh]

Very well explained!!
I would like to know if I want to run/stop the drive via digital inputs only and speed reference to give only via profibus, what parameters do i need to set for that?
As of now when I established the communication via profibus then now I'm unable to start the drive via digital inputs!!
Please help me with this

[gouravgaming]

Sir, please make a video on SIMOCODE programming with s7-300 plc and control from HMI TP-700 Comfort. It will be really helpful.

[raviprabhat]

Please upload a similar video for S7 300 communication with Parker 590 or 690 plus drive..please

[palanipps]

Sir one doubt could you plz?. the Gsd file is common for all Siemens model drives or different gsd files for other model Siemens vfd?

[imranmirza]

thanks brother super effort please suggest me TIA Portal version which you are using in

[andreicaza]

I am getting a Fault F1910 and I do not know why. I am using your codes 047E, but the moment I put "HIGH", it gives me that fault. Do you know why?

[motor]

Parameter to Drive g120 ??? .
For setting profinet

[inaramara]

please sir, from where you are getting those codes for words ?

[ameysawant]

sir, can you please tell me, how you calculate that hex value to control drive.