How to adjust the high & low beam height of Sunpie 9' RGBW headlights for Jeep WranglerJL Gladiator?

The Jeep Wrangler JL/JLU and Jeep Gladiator headlights were upgraded from 7 inches to 9 inches in 2018 (inclusive) and onwards, compared to the previous version (Jeep Wrangler JK/JKU). Like a barrel,Drawing inspiration from the iconic design of the Jeep Wrangler JK 7-inch classic headlights, we have developed a 9-inch RGBW classic-style headlight.The size and rear shell of the original headlights have been changed. When fixing the headlights, you need to use additional screws to adjust the height of the high beams and low beams.

Open the hood.

Locate the hood release lever inside your vehicle.
Pull the lever to release the hood.
Prop the hood open using the support rod.
Locate the headlight adjustment screws.

The headlight adjustment screws are usually located near the headlights.
There may be one or two adjustment screws for each headlight.
Refer to your vehicle's owner's manual for the exact location.
Adjust the headlight height.

Use a screwdriver to turn the adjustment screw clockwise to raise the headlight.
Use a screwdriver to turn the adjustment screw counterclockwise to lower the headlight.
While adjusting the screws, observe the beam pattern on a wall until the cutoff line is 2 inches below the center of each beam.
Close the hood.

Make sure the hood is securely closed.
Return the hood release lever to its original position.

[robmorley]

2021 JL. My RF assembly does not have enough adjustment using the supplied springs. It points way high and to the left. I believe it is a mfr issue. Please advise. Thank you.

[BenzingEj]

What a terrible video, also this doesn’t even work