Power Injection Board

Designed by Andy Harrison, I had the chance to assemble this unit and test it out. Very happy with the testing. I have use for a number of these units. I plan on each controller having one for power injection.

Andy is currently running a pre-sale co-op till February 21, 2016 for these boards. After that, we are looking to make them available online after the end of the pre-sale.

To order yours, follow this link:

Once the pre-sale/co-op is over, we will have a better idea of how to keep these available the rest of the year.

[SpectacularV]

New to this hobby! I find your videos very helpful. Thanks

[blackwolfacres]

If there is some distance from your controller board and power supply, wouldn't it make more sense to run one set of longer, larger wires to the board and then place the board near the pixels in a waterproof container, then use short smaller wires to the pixels.

[slim]

Thank you for all your videos, I am slowly learning from each. A question that I have is in regards to the pig tails. I would assume that each wire is assigned to one of the connector pins on the male ends of the tail. If so, how is this determined? My concern is that I might connect a male power into a female data or neutral ECT... I hope this makes sense and again thank you.

[pyzze]

like the board can i have it to sweden ?

[johndill]

I need to run 1000 per output 3 in about 250 feet how many wires and gauge to power inject at the end

[MacWarriorOH]

Clyde, so how do you connect the distro board from the pigtail into your lights with the data? Thx, David

[markaamber]

All your videos start with "Clyde here LIVE at Leechburg Lights..." But these videos, are NOT live. Just sayin'