How to lower ANY truck FOR FREE

check out my latest video for results

In this video i give a brief explanation of how to flip your leaf springs on a truck, which will give you a 5 inch drop (about). This can be done with common hand tools (with the exception of a welder) and is relatively simple.

[rwkrauss]

(Removing Thingies) This little thingie and that little thingie can be removed from that little thingie that holds that big thingie but be careful not to remove to many thingies at once or you could have thingies all over the place and that would be a real mess of thingies to clean up! but all this thingie clean up can be done for free if you become a thingie expert.

[jimcollins]

This is something that's been done to trucks for about as long as they have mounted the springs on top of the axle .Easy job to do and I have done it many times for the last 30 to 40 years . But some frames don't have a high arch and can hit the axle unless you modify the frame to clear .

[gearhead]

That "little block" is a spring perch. You can buy them new from summit according to your axle tube diameter.

[unbreakable_mazapanll]

“Engine puller thing” lmaoooo let me just hop off this vid. 😂

[garysmith]

The “block” is called a spring perch. That truck doesn’t have blocks.

[clubfreeze]

Did you lower the rear ??? All I got was a lot of talking

[whotrethatyoungan]

I have and 93 ranger and it’s a stick I wanna lower my back want it and lil squatted cus the back like 2in taller than the front but don’t want my clutch to mess up

[Joe-xjtb]

Could one just flip the springs? What would that get?

[chazpaul]

Everytime I skip forward uhh uhh uhh 😂

[chrisford]

This fucks your truck up ruins the value an makes it ride like a horse an buggy

[LusiTron]

you can flip the axle so the perch is at the bottom. You'll have to make sure the driveshaft clears everything. Ghetto, but it works.

[rootiest]

if u flip the u bolt like that all of the rear weight of the truck will be held by the 4 nuts of the ubolts bro. that doesnt seem like a good idea

[slowmotionperformance]

What an asinine thing to say. Culture Vulture

[NaterAnderson]

So how come you did not show us in this video? I call bullshit

[jmata]

What welder did you use and what about lowering the front?

[lmfao]

It is never free cause when you lower it you need new shocks and a c notch

[zems]

Couldn’t the rear end be flipped from side to side? So, in essence the drivers wheel would be flipped over to the passenger side and Vice versa, The there would be no need to cut the locator block off of the axle it would reside in the same location. The only concern I can see would be the gears, but since the Drive Shaft is still rotating in the same direction I think the gears would be fine.

[thyubernoob]

Those springs are not riveted on the ends, those are wear pads...🙄

[billdavis]

I’d love to meet the first person to squat their truck. If we could reverse it, like have the front lowered with rear jacked up! Who cares about safety! It’s all bout looks!

[jefflilyea]

Not free. Shorter u-bolts and shocks $$