VLT AutomationDrive Quick Start Tutorial

Learn how to start up your Danfoss VLT AutomationDrive using the award winning easy-to-use local control panel (LCP). The well-structured menu system ensures fast commissioning and easy access to its powerful functions saving you time, energy, and money.

[paulikass]

Very useful information, thanks for the video 👍👍

[erbayerbay]

It works again after a power outage and when it comes back on. How can I stop this?

[basilisraptakis]

Hi, IGBT brake module is only if i want to connect brake resistor? If i want to use dc brake without resistor, can buy the drive without IGBT module?

[lastfirst]

Is it true these can be set to supply a small current to the motors when they are off to keep them warm to keep moisture out? If so, how does one program that?

[emadmohmed]

Fan always work and give heatsink temp error how I can fix this ?

[humbulanimathisa]

I cant save the changes, every time it just go back. Could this mean the drive is looked?

[mashudumawela]

How do I activate the "Hand On" button if is disabled. Everything when I want to run the motor on manual it says "Button Disabled"

[erdaltas]

Hello, thank you for your videos.
Relying on your experience, I have a question about danfoss fc302 cranes liebherr. The driver works for 2 days without any problems. Sometimes the free stop passes and the load is released. The driver came to our workshop for repair. We suspected the control card. When you replace the control board, the panel freezes, but it displays an internal fault error (A38). power card does not recognize the control card. This is the mco 351 card with drivers with liebherr cranes application. How to solve this problem should be followed.
THANK YOU.

[JoseAntonio-ttmb]

Good morning how i program reverse in danfoss FC 301?

[Hamdo-lillah]

merci beauque pour le vidéo, s’il vous plait, j’ai un question. comment fournir un tension 24vDc pour actionne un bobine de ( contacteur ou bien distributeur ) lorsque le vitesse de variateur 100%, et priver 24vDc si la vitesse <100%, les étapes pour programmer le variateur danfoss

[manishjoshi]

302, 75kW, drive power board defective, how to know component detail due to coating on the board, not possible to read.
Any checking procider to repaired power card

[wahyunugraha]

Sir
How to change analog input voltage to current mode? Because 6-11 and 6-12 is missing.

[jorjiosapigao]

hvac volt drive.its possible to dc input voltage

[Bosanac_]

I cannot find what type of sinus vawe filter (serial output filter) is recommanded for Micro FC51? Please, any recommendations?

[md.shohashrezabadhon]

I can't unlock the password.
Some one lock the cpu.
I can't do factory reset

[manishjoshi]

102 model 30kw drive power card defective, heat sink temperature too low fault message display..
How can. I repaired it

[emmanmiclat]

Question: can we program a timer settings? how?

[bhimshrestha]

Hello sir, I have problem on danfoss vlt fc 302 model drive.the problem is that, , , sometimes it signal short circuit, or some time, V phase losses after running half an hour.

[rahemansaha]

my VLT Control Panel LCP31 Ordering No: 132B0200 showing Gate drive Voltage fault how to reset

[niki]

How to change the maximum cut-off pressure for water pumps?