How to replace the Raritan 87 Icemaker Cold Control

Transcript:
How to replace the Raritan 87 Icemaker Cold Control
00:47.13 Begin by removing the grill.
00:54.00 Using a 14 mm wrench, remove the retention nut for the cold control.
01:02.00 Lower the cold control and disconnect the color-coded wires. Carefully noting the terminals in which each wire is connected.
01:13.90 Remove the back panel screws to remove the cover.
01:24.00 Partially remove the sealant over the sensing tube’s entry point and gently remove the sensor.
01:33.00 Carefully unroll the new sensing tube on the new cold control.
01:42.00 Carefully route the sensing tube to avoid damage.
01:50.00 Reinstall the wires on their appropriate terminals.
02:06.00 Mount the cold control using the alignment pin in the indexing window of the bracket.
02:24.00 Insert the temperature probe through the cabinet and into the mold cavity, ensuring the probe reaches its maximum depth.
02:34.00 Route the sensing tube down the back of the unit and carefully spooling any residual amounts.
02:45.00 Reapply the sealant to putty over the opening.
02:50.86 Reinstall the units back panel.

Raritan Marine Products-Setting the Standard in Marine Sanitation

See Our Full Line of the Best Marine Sanitation Products on the Market
Macerator Pumps
Macerator Toilets
Marine Toilets
Electric Toilets
Manual Toilets
Marine Hoses
Marine Water Heaters
Marine Ice Makers
Marine Sanitation Devices
Marine Holding Tanks
Boat Cleaning Products

Other Marine Products Videos

Raritan Marine Sanitation Products
530 Orange St. Millville, NJ 08332 Phone: [phone]

Contact us on our other Marine Products Social Media Channels: