How to remove a transmission 1994-2004 sn95 mustang (t45, tr3650, t5)

preview_player
Показать описание

Рекомендации по теме
Комментарии
Автор

It's been 4 years but nobody commented about the shift knob, however i would love the shift knob i have a white sn95 with a black interior on the very off chance you still have it

hunternarciso
Автор

This is a transmission removal video yet you skip the whole part where you actually remove the transmission from the engine. You would think that would be a very important and crucial part of the video about how far to move back drop down etc. Super bummed sucked out 12 minutes and 12 seconds of my life that I'll never get back.

zackrichardson
Автор

13mm for the drive shaft. I got them off with a regular 6 point and a little tappy tap tap and my big haus 1/2 impact but i boogered the bolts up a bit. Definitely use a 12pt wrench. Especially because the bolts got stuck in the socket requiring me to heat them with a torch then drive them out of the socket with a screw driver holding it with vice grips slamming it on the concrete floor. (Btw this trick works 100% of the time if you get a bolt stuck really bad) Always use the right tool for the job if at all possible. I am just a stubborn idiot who likes to work hard not smart.

misterbulger
Автор

Thanks bro ! I got it from here hopefully

jstaysydewayz
Автор

Thanks for the Video very informative however there are 3 bolts on the starter not 2 and the top bolt is extremely difficult to remove I would say once you remove that bolt you are good to go.

tovich
Автор

Great video! Curious how much time it took from start to finish. If you mentioned, apologies, I might have missed it. I have a 98 Cobra and I'm thinking of upgrading the transmission. Not a fan of the T45. I have a lift so it should hopefully go even smoother than how yours seemed to have gone.

jmrandom
Автор

Nice and Informative, Keep posting new videos ! New friend Here.

AadisChannel-Original
Автор

I have a 1994 mustang gt. Do I have to drop the transmission pan? or do I have a bolt to drain the fluid?

TeloShort
Автор

doing a t56 swap and never pulled a trans before. Not yet youtube certified...

scottsorensen
Автор

I had to remove my transmission and put it back in now it’s not shifting any ideas

Tht.rt
Автор

Dudes sniffling was too much for me to watch past 3 mins lol

jordonbaker
Автор

about to pull the trans and engine for the first time. Btw wana sell those seats lol?

sandmansimms
Автор

.. u didn't really show how u got it out ... 👎👎

jcnmyboy
Автор

You really made a video on how to take the transmission out then skipped the part where you take the transmission out, 100% waste of time.

WillDemerchant
Автор

The while reason I wasted my time in this video was to SEE HOW to remove the transmission from the engine happened, which bolts, issues...etc. FAIL!

rickhoff