How Does Auto Bed Leveling Work?

This video is a brief introduction of how the auto bed leveling works on our printer. To see how to use it in specifically, please refer the auto leveling video tutorial:

Music:

For Mimi --- Twin Musicom

[tiantian]

I always thought there were motors inside that turned the screws until the bed was level, not the z motor making adjustments if the bed is off-level. Thanks!

[dawidsosna]

hello:) bardzo fajnie wytlumaczone...ogladalem duzo filmow na ten temat i w zadnym nie bylo tak pokazana czy wgl powiedziane. dzięki :)

[abhijittdhavlle]

Thanks for the video! But my ender 3 pro with bltouch doesn't seem to work like that.... every time it prints, it doesn't print uniformly, some points are clear while others are smudged and kindly suggest what is going I also have tried saving the settings to EEpROm, yet no I have to do the babystepping adjustment for every print.

[henmich]

Is it planar? As in what if the print bed has a sag from heat? Will it accommodate for that, or just pick the best flat plane?

[_micha__]

so all this makes the z motor move and stuff, how often should i use it before every print? or should i add to gcode the g29: Level The Bed or i can do it before the print and it would remember?
Thanks

[pyterbarros]

Is the automatic bed alignment only performed once, or every print start?

[sotospt]

So the print will start and the bed might be skewed. Do you guys think that this is right? I would prefer the old fashioned way, "spend 10 minutes before every print to level the bed"

[Mattchee]

Thank You. it will compensate, but the piece will be crooked when set on a flat surface? No?

[hddbc]

Wont this wear out the z motor and the screw quicker

[ArcanePath]

What the hell kind of accent is that? She sounds like she comes from everywhere.