jcb 3cx bearing 2 csapágy

[sinanmahmood]

Thank you, I will need this video next two days, same problem in my 3CX

[DicksonMulamata]

I'm learning this for the first time, but I am a mechanic in Light vehicle

[zsoltborics]

Kedves Laci!
Van e olyan Videótok amely a vàltórol szól?
Üdvözlettel

[ismaeltibaduiza]

Donde comprar repuestos para jcb 3cx modelo 1989

[nasimansarijcbmekenik]

Shir mero ko bhi jcb mecnik ka bija mile ga

[leonidgolomedov]

Хоть русский, хоть не русский человек, всё равно всё мажет ПАЛЬЦЕМ, герметик, хоть смазку...

[olegok]

Не нужен там герметик. Сальник не стал на место. Пыльника нет(

[elviejoperro]

Very good video, very detailed thank you, little to much silicone doe.
Best regards

[jarosawkamczynski]

You should heat bearing before assembly. It will be easier to put it on shaft.

[jarosawkamczynski]

What's bearing type used for replacement?

[olegok]

Ковш покрасить не забыл. а нож не поменял(

[wesleylulini]

Nao precisava nem retentor, foi tanto cilicone que isso nao vaza óleo nunca mais kkķkkk

[balazsszeghy]

9:06 Miért nem melegítetted meg egy kicsit a csapágyat és akkor kalapálás nélkül is rá ment volna a tengelyre

[tomekscania]

Rumuński Jarek Ogarek pokazuje jak nie naprawiać koparki. Paproch na medal

[jondoherty]

Hammering a dry bearing that a no no You heat up the bearing goes on a lot easier

[Danio-zk]

Niestety naprawa źle wykonana, brak osłony przed uszczelniaczem spowoduje dostanie się piachu czy czegokolwiek i wyciek od nowa.

[johncone]

The seal should be put into the hub not as you have done and also the seal should not be run on top of a coat of paint. Bad practice.