Configure EtherChannel (PAgP and LACP) in Packet Tracer

CCNA Routing and Switching: Configure EtherChannel (PAgP and LACP) in Packet Tracer

[siredogitto]

Man you saved me, I was just looking for a tutorial to explain to me these configurations and a friend recommended me this video. Thanks a lot!

[Impactever]

i was just reading about the subject in a Cisco press book, thanks for being so clear, its very helpful.

[TheToxicDave]

The video is great man. You explain it clearly and I like the point "Now we verify the configuration..." :)

[williesolomon]

Impressive video tutorial. Thank you for sharing. God bless you.

[M.Suliman]

thank you alot of --
how to check the result? the throughput and bandwidth?

[iiNGHMRii]

thank you tech acad!!!! i have a question... whats the difference between configuring a Port Channel group and choosing those interfaces? Example:
conf t
interface range fa 0/5-6
OR
interface port-channel 3

whats the difference? thank you!!

[infopc-arieh]

Excellent ... well done ... with Scripts ...

[thepuldarshana]

hi, So you go to port channel and make it mode trunk. that is ok. so does it need to go in to physical interface and make it trunk too ? thanks

[prabhus]

It's very useful, could upload more videos.. thanks

[MochammadFajarKurniawan]

how to check the result? the throughput and bandwidth?

[thispakistani]

When you run show spanning - tree command one of the link show block

[amam]

god bless <3 <3 <3 <3 <3 <3 <3 <3 <3 <3

[rasheedmalik]

simulation could ve helped u explain in a better way about load balancing

[adhithyaasharma]

you have thought pin to pin the video great and very informate can you please send the note of that common which you have write in the side

[Siva]

In onw word,
print(" thank you