✨ LG DISHWASHER - NO POWER - How To FIX ✨

✨ LG DISHWASHER - NO POWER - How To FIX ✨
This Video shows how to easily replace the power line filter when your LG Dishwasher no longer has power. Always first check the outlet the dishwasher Is plugged into to confirm the outlet has power.

If the video was helpful, remember to give it a Thumbs Up 👍 and consider Subscribing. New videos every Saturday ✨

-If My Advice Has Helped You…

Disclaimer:
Because factors beyond the control of Scottthefixitguy, I cannot guarantee against improper use or unauthorized modifications of this information. Scottthefixitguy assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Scottthefixitguy recommends safe practices when working on appliances and vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Scottthefixitguy, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Scottthefixitguy.
Thank you 😊 *
*
***

[smiley_crafts]

Wonderful step by step DIY repair video! Thank you!

[tomrenner]

It worked! Called LG. They referred me to an "authorized" repair person who when I called said they don't do LG and don't know why LG would refer them. He gave me another "authorized" repair person who when we contacted them had the same answer: "we don't do LG". LG Service is an absolute trainwreck. Went to the store where we purchased in in June, 2018. They do were not helpful. So I turned to YouTube. Tried to the power off, tilt, reset. So grateful.

[joebarry]

This fix worked for me. Since the Dishwasher is about 7 years old, I decided to put in a new pressure hose while I had it out. Total parts was about $70.00. Thanks

[lisalisonbee]

This tutorial helped me fix my dishwasher!

[JPOrtiz]

Just had this happen to my lg dish Washer too.. Same exact symptoms... Feeling confident I can fix it with this easy to follow video

[grahamdarby]

Many thanks for this. I also found the fuse blown in the noise filter. Replacement part was Can$ 90 delivered from Reliable Parts. The phillips screw was impossible to remove and I cut through it with a small hacksaw. Secured the new part with a screw from the outside. I wonder if a $2 fuse would have fixed it?

[randywalker]

Thank you this shows a lot on how to fix my issue.

[scottholladay]

This video was a good start, but what if the fuse in the power filter module is intact, so you have AC power getting to the control board, but there is no display?

[markturner]

I also had a bad power line filter. It was discolored around the fuse, just like the one you showed. It also melted the plastic tray where the fuse is mounted, on the bottom you could see the solder pads had overheated and deformed the plastic also. It looks like the fuse is overheating and the solder pads are too small. After replacing the filter I measured the line current and it was 10.45 A. Well within the ratings of the fuse (15A) . I think they need to address this problem. A short term “power spike” would not cause the plastic to deform

[huskymoto]

I have exact same dish washer. Do you have the part number and website you ordered the line filter from? Thanks for posting

[cariwaller]

Thank you so much. I followed your video and fixed my own dishwasher!!! I don’t own the tester thing so took a chance that it was the noise filter assembly. It was. Thanks again!!

[rockingcheers]

Perfect! It was a 6201EC1006T that I picked up today from Reliable Parts. After checking the main board and switch which were both fine, this filter board was the culprit. Thanks Scott. Other than a card, this is the perfect Valentine's Gift for my lady.

[robertearlburke]

Thanks, mine turned out to be loose electrical connection at power supply - I guess wire nut was not tight enough from initial install, and it vibrated loose over time. Tightened wire nuts and turned on circuit breaker, and back in business.

[CarlRMauri]

Scott: Not just good: EXCELLENT! great video, great safety procedures, and great meter stuff. I needed a better visual of checking the noise filter fuse but other than that awesome!

[BenMagargee]

Thanks for the video! I was having this exact problem with my dishwasher and this video let me know it was relatively easy to fix. Turns out, my power cord was just loose, so the hardest part of the fix was getting out the stripped screw from whoever installed the thing.

[kimf.]

VERY informative ! I had same thing happen to me..no power on my LG.. model LDT5678ST. I had a service guy come, checked breaker and plug (which i obviously did first too). he didnt look inside the dishwasher ..he didnt remove anything. he quickly diagnosed that it needs a new front panel ($500+). was that a hasty diagnosis.. could someone tell that quick without looking inside . the dishwasher is only 2 1/2 years old. to me it seemed pretty fast without looking at anything else..but that may be standard. thougths? thanks!!

[thandrage]

Hey Scott, I am working on a very similar dishwasher and it’s not powering on. Before it was, and I replaced the main motor that was burned out and shorted to ground.
I checked both fuses and the door latch. What do you think I should do next?

[toze]

hello I have an LG d1453wf dishwasher and I'm starting to get tired of it because the touch buttons break down a lot, and now it was the water pump in 5 years it never gave me rest I'm fed up LG DISHES NEVER AGAIN ...however the LG machine washing machine is TOP
Good job...

[BackFiremm]

Was it the glass fuse that you tested? Your camera did not show that part..

[AWESOMELawsonDIY]

Great job on this video, cant thank you enough for the tutorial. You helped me narrow down, and fix my LG dishwasher. Keep up the great work.