Automatic Cut OFF/ON Battery Charger Controller | XH-M603 DC 12-24V Battery Charger | POWER GEN

PCB order website
Prototype PCBs for $2 + Free Assembly

This video shows the XH-M603 Automatic Cut OFF/ON 12-24V battery Charging Controller Module using 12v Lead-acid Battery Charger Control Switch Protection Board With LED Display Automatic ON/OFF Real-Time Voltage Monitor

________________________________________________________

material buy the following a link
XH-M603 automatic battery Charging Controller Module

---------------------------------------------------------------------
Click the link see the more videos on the playlist

-----------------------------------------------------------------
buy more material by the following a link
Power Bank -
18650 Li-ion 3.7v battery
TP4056 Li-ion Battery Charging with Protection Board
DC-DC 12-35V 150W Boost Adjust Module -
3S 20A Li-ion Battery 18650 Charger PCB BMS Protection Board 12.6V Cell -
LM2596 dc-dc buck converter step down module =
MINI DC 0-32V 3-Digital LED Display Volt Meter
Solar LED Wall light
MT3608 2A dc-dc Step Up Boost Power Module =

[suryadiyuda]

May i ask you, how to use this pcb for solar cel

[tupai]

Can put solar panel to the Input module?

[satheeshbabub]

Can this module take input of 20V from laptop charger and charge a Lead Acid 12v battery without any problem? I am worried because the laptop charger output 20v but battery is a 12v battery. Start charge volt i am setting in the module is 11.5 and cutoff voltage i set is 14V.

[zaferibrahim]

Hi
If the volt in the circuit is 30 v frome solar panels can I charge batterie 12 v
Not 24 v ?
So from 30 v can I charge 12v battery?

[stephenshop]

Hi. Can i set the connect value to 13.4v and set the disconnect value to 13.7v?

[lifeafterlife]

Hello, listen to the amps how are they managed? I need to charge a 12v 12A lithium battery pack. If I put a 1A charger on the battery does it get 1A? Thank you

[gustavovinicius]

hello! Good afternoon. How much is the minimum voltage I can configure on the inferior limit? Thank you for the video

[stfn]

Hi is possible attach a load in parallel of battery ?? thanks

[thTek]

great video, annoying sleepy music ...

[aldinshobby]

Can I use the normal USB to power up the board?

[ZeroCarbo]

can you set 0.00 as the lower voltage and turn on ? im sure not

[alaskhogaming]

can i used this to my DIY 3s 12v 25ah LION BATTERY

[yehudagoldberg]

Can you explain how to wire an external relay?

[pardharavada]

In jlcpcb, are we can buy total module or only board with out parts?

[maakamala]

Can I use it without voltage booster module ???

[sallum]

Hello ... can we make a cut off also which gives power output only when the desired voltage is available from solar panel and if it goes below the reqd voltage it cuts off the supply to the appliance??

[nirfanalfandy]

do you have data sheet XH M603 / XH M604? for my final project. because I really need it

[ionmarius]

for 6 v acid lead battery ? do u have any recomandation?

[agentxyt]

Hi, you are using transformer for 220v right?

[arielando]

is this suitable for 100 or 200ah battery Sir?