3000 and 4000 Series Ford Tractor power Steering Pump Leak Repair and Filter Change

In this episode, we diagnose and repair a power steering pump leak and change the power steering pump reservoir filter and “o” rings in a 3000 series Ford tractor.

[j.b.]

Tip: Before removing the reservoir cover take a marker and draw a small line across the pump onto the cover. This will give you a point of reference when installing the cover to line it back up exactly where it was.

[mikeprice]

Everything but what kind of fluid do you use

[mikepursell]

I feel like I've been to Ford Tractor school and had the in depth course on power steering ! Wonderfully done !

[michaellohre]

I really appreciate the detail and care that you put into the work and the video. May God bless and keep you in all your work and service, Dan. You really have a nice looking Ford there and well cared for. It makes me want to do better on my 63 Ford 4000.

[DanHarrip]

Awesome video Dan thanks heaps exactly the video I’ve been looking for 👌

[jamesevans]

What is the easiest way to flush the system. .?

[jessemixon]

Nice job sir, of carefully explaining how to assemble the parts so as to avoid damaging the parts and fittings

[gaminawulfsdottir]

Step One: Have your cameraperson turn the phone sideways.

[philliphall]

Some old ford trucks 800 series used this same pump. I save 3 for my old ford tractors

[danelliott]

The wire that connects to the oil pressure sending unit should just snap on unless the connector is damaged.

[cloudyeight]

Thank you for the video! This helps a lot.

[gregwiese]

wearing rubber gloves thinking HARD .... ? something is MISSING ... I don't get it

[joshnaranjo]

Good video. Thanks. I've changed the other hydraulic filter at bell housing. haven't done that one because I didn't know a filter existed there.lol

[justinclinard]

Did you use ATF for power steering fluid

[joshlismore]

is this how they leak back into the block or is the leak to the block caused by a o ring fail on the drive assembly of the pump?

[Theearswe]

How did you get the cable for the oilpressure to stay put? I Dont get it?