Step by Step Upload Code to WT32 ETH01 from Arduino IDE

preview_player
Показать описание
Step by Step Upload Code to WT32 ETH01 from Arduino IDE

Please watch my another video how to upload code to WT32-ETH01 from Arduino IDE:

Requirement Hardware:
1. WT32 ETH01
2. TTL to USB UART
3. Mini Project Board
4. Cable Jumper
Рекомендации по теме
Комментарии
Автор

IO5 has the built-in LED, not IO2. That is RXD2

jensschroder
Автор

It is not good to connect the IO0 pin to GND but forget the GND connection to the board.
You always have to have a GND connection.
The IO0 for programming to GND and open to run.

jensschroder
Автор

You shouldn't connect IO0 without ground connected. The device can burn up. This is a risky video. You should re-edit and re upload.
Appears to be a confident knowledgeable video. But its not. You could change this with an edit. All the Best!

StageLightingVideos
Автор

Turn off the music! Other than that, thank you.

christerharrysson
welcome to shbcf.ru