filmov
tv
Nami Burn-e Tyre Change Tutorial
Показать описание
Step 1 – deflate the tyre by removing the valve core
Step 2 – Remove the motor cable clips
Step 3 – Remove the calliper
Step 4 – Remove the wheel nuts and washer being careful to support the wheel
Step 5 – Heat the disc screws and then remove them as well as the disc
Step 6 – Break the tyre bead
Step 7 – Insert the tyre levers and use the scissor technique to remove the tyre
Step 8 – Make sure the new tyre is the right way round before fitting
Step 9 – Use tyre paste to lubricate the bead
Step 10 – Press the tyre down over the rim
Step 11 – Use the tyre leavers to ease the tyre onto the rim at one end
Step 12 - Repeat the process until the tyre is seated
Step 13 – Now replace the valve core
Step 14 – Inflate the tyre to near maximum PSI to seat the bead
Step 15 – Reduce PSI for personal preference
Step 16 – Clean up the wheel before refitting
Step 17 – Replace the disc making sure it is facing the right way
Step 18 – loctite disc screws before fixing
Step 19 – Replace the washers and slide the wheel onto the swingarms make sure it is the right way round
Step 20 – Add Loctite to both sides of the axel and torque axle bolts to manufacturers guidelines
Step 21 – Replace motor cable clips and use Loctite on the screws
Step 22 – Replace the calliper and use Loctite on the screws
Step 23 – Replace the dust cover on the valve and you are finished.
Step 2 – Remove the motor cable clips
Step 3 – Remove the calliper
Step 4 – Remove the wheel nuts and washer being careful to support the wheel
Step 5 – Heat the disc screws and then remove them as well as the disc
Step 6 – Break the tyre bead
Step 7 – Insert the tyre levers and use the scissor technique to remove the tyre
Step 8 – Make sure the new tyre is the right way round before fitting
Step 9 – Use tyre paste to lubricate the bead
Step 10 – Press the tyre down over the rim
Step 11 – Use the tyre leavers to ease the tyre onto the rim at one end
Step 12 - Repeat the process until the tyre is seated
Step 13 – Now replace the valve core
Step 14 – Inflate the tyre to near maximum PSI to seat the bead
Step 15 – Reduce PSI for personal preference
Step 16 – Clean up the wheel before refitting
Step 17 – Replace the disc making sure it is facing the right way
Step 18 – loctite disc screws before fixing
Step 19 – Replace the washers and slide the wheel onto the swingarms make sure it is the right way round
Step 20 – Add Loctite to both sides of the axel and torque axle bolts to manufacturers guidelines
Step 21 – Replace motor cable clips and use Loctite on the screws
Step 22 – Replace the calliper and use Loctite on the screws
Step 23 – Replace the dust cover on the valve and you are finished.
Комментарии