How to test your ebike display cable voltage?

If you do not get any power to the display, we recommend you to test your ebike display cable voltage.

Step:
1. Unplug the display cable
2. Plug two drawing pins into the display cable
3. Please have your multimeter set to 200 in the DCV section Direct Current Voltage (DCV)
4. Test the display cable voltage

Please feel free to contact Wallke eBike service team, if you have any questions.

[bertcolbert]

Thank you so much for posting this video! You helped me figure out that it was the display screen on my wife’s Rad e-bike that went bad and not the control box.
Two Paper staples work perfectly.

[robertunda]

Wow couldn’t find a paper clip but had tons of staples some body said always use your resources!! Thanks for the enlightenment .

[JustinSkaar-lh]

Is 46.2 normal and working in this case or are we expecting to see 48-54?

[Guitarecheval]

Hi, I have a twist throttle with Julet connector green five pin . It works great but I want to replace with a thumb throttle . Twist take too much place . Where can I buy one thumb throttle please . I can't find anywhere . If it doesn't exist, can you tell me the tension on the female connector to make one by myself . Where is 5v ? GND ? Signal ? Horn switch ? Thank you

[jimzigzagman]

Thanks for the video. I used safety pins. :)

[iamgreyhorse]

What is the name of this type of cable ?

[CursedHourss]

Does anyone know if i can place a throttle onto my display cable?

[valeriilocmelis]

A 52V battery will withstand a maximum of 58.8V

[Batemarrmb]

Never pull electrical cables apart in this manner 😢