Manitowoc water level probe troubleshooting

Manitowoc ice machine not working properly. Water was over flowing the water trough during the fill cycle. Removed and tested the water level probe.

If you found this video helpful please consider supporting the channel on Patreon.

[crystalcleanappliance]

Im about to binge watch your videos, thanks for sharing. Interested in learning more about this service

[charlesrios]

Always looking forward to your videos. I learn a lot. This water trey episode is one of the best

[michaelblake]

I recently started working for an ice machine company in OR. I don't have much experience with this stuff, but I am learning as much as possible, and your videos are very helpful. My goal is to become a full fledged tech at some point, so I am very grateful for all of the info you put out. Thank you.

[jerkyjohnny]

I’ve been switching out water fill valves, now I feel dumb. Thanks Dawg!

[brayanrodriguez]

Nice video and thank you for show us how to check stuff.

[Daddy-epng]

Quick question. When its in current making ice mode and water level gets below sensor, is the board supposed to then get signal to supply more water to evap and curtain if ice sheet still not to right thickness and ready for harvest? Working on one now and noticed that water pan gets so low and the thickness switch isn't ready to harvest yet, but there is no more signal for more water to be brought into pan for wayer pump to keep pouring over evap as needed.

[RockyStar]

Well just cleaned another and this one the probe was loose when I put it back in. I just took it out and tested the continuity and it’s not getting any at all from the plugs to the pins. The little silicone piece is also loose and comes up off the part it wraps around at the bottom. It seems like maybe the whole thing came undone or something.

[natethegreat]

Our companies brand new, maybe a month old Manitowok ice machine has been having the issue of water trough overflowing constantly, however water probes have been switched out and hasn’t made a difference, it’s sort of intermittent, we had a second machine brand new sitting on the shelf so we hooked that one up and it is having the same issue… could it be a water issue? Maybe not enough minerals in the water to consistently cause the probe to ground out like it’s supposed to?

[Goldenb.f]

Watching from Philippines..thanks to your videos..such a helpful 😊.done subscribe

[mankgamorokolo]

My Koolair ice machine water pump it runs and stop .can it be switch float

[Supanova]

id0906a-261 harvest sequence when does water go over evap right away when turned on?

[davidmoses]

Ok I'm having this problem ... I pulled the part here in video and test mine I got tone on all probes but still have this issue with thick ice drops . Any advice would be helpful

[RockyStar]

Ugh I cleaned ours and now the water isn’t getting high enough to touch the probe. I hate these dang machines

It dropped ice literally after I sent that lol

[OcRefrig]

Good video ! Subbed. Liked. I just got a video call from a customer - ice o matic ice0600HA4 water curtain drops into the bin when it harvests. Lol 😂 never seen that one before I think. Gotta go check it out.