How To Fit WREN Kitchen Wall Units - DIY

If your like me and love doing abit of DIY or on a budget and cannot afford to pay someone to fit some kitchen units, then check out this video where I try and show you a step by step guide on how to install kitchen wall units from Wren, this can apply to other kitchen manufacturers as well as the concept is the same however fixture may differ.

if you found this video useful please give me a like and don't forget to SUBSCRIBE please.

Thanks

*Process is the similar for units from B&W, Wickes, Howdens and other DIY stores.

[anoushkawalton]

I’ve just been quoted 3k to fit a pre built wren kitchen 😮 and I found your video - you’ve made it look so easy. I might install it myself 😂

[iansulli]

Way better than thee Wren video. Thanks

[ksp]

Thank you! Can you do a video adjusting the kitchen door hinges. Mine have become uneven with use 😞

[mousaskos]

Do you have another video showing how you mount the next unit ?

[stevenharrhy]

Thanks buddy, that was a great help 👍

[nirvanka]

What screws did you use for the bottom? What would you recommend for a very hollow plasterboard wall for those bottom screws? Anything I researched requires a plug to be inserted into the wall first, but that is a bit challenging to predrill in the right place given all the adjustments that are done after you hang the cabinet and lock it in place with the red screw.

[akewt]

Thank you! Helping with mine install a lot. :)

[studio-wabi-sabi]

Great video. Are those plugs strong enough for plasterboard on a stud wall. I was going to use expanding wall anchors, but I'll take the plug option if they do the job? And are you using 6mm screws?

[spiders]

Great vid. Question - how do you know what hight to fit the brackets to get the correct height on where you want the units?

[NickBunton]

Thanks for the video. We are ordering a Wren kitchen, and I want to fit it myself. Your wall looks like it's just been plastered, but did you need to scribe to the back of any of the units to make them fit the wall properly, or would that only be end panels? I am trying to find a video that may cover that.

[TheStanth]

Hi, mine were fitted several years ago but we've noticed they coming away from the wall. The brackets on the wall seem to be ok - so I don't think the screws are coming out of the wall.
However I cannot get the main screw from inside the back of the cabinet to tighten more, was hoping this was needed to push it back to flush to the wall.
Another issue is the holes are not long ones like you have but round and doesn't seem to be enough of a hole to properly reach the screws (it;s at an angle probably because the cabinet is so far away from the wall now).
Can you suggest what to do?

[Stephensclips]

Did you fit Decor panels to the ends of the units, or any pelmet or cornice?

[jonathant]

You would make it easier to fit the next one if you left the double bracket as a double, so that the same bracket supports the right hand side of the first cabinet and the left hand side of the adjacent cabinet instead of cutting them all into singles.