ford super duty front passenger axle u-joint replacement

In this video I replace an axle shaft u-joint, and install a new axle seal on a 2012 f-550. I attribute my successes to god and give him the glory. for we are his workmanship created in Christ Jesus for good works, which god prepared beforehand, that we should walk in them. Ephesians 2:10.

[brycemaggio]

Been pressing and heating for ages (everything rusted to shit obviously) 91 ford HP kingpin. Used to Dana 30’s. Didn’t know there were inside clips. Thanks man! 👍

[АлександрАнашкин-рд]

Радостно что человек занимается делом с душой . Приятно посмотреть .

[outdoorsadrenaline]

Thanks for sharing. Helped me out and good job being thorough!

[grampabadger]

A bit easier than doing the same job in a muddy barn yard and having to use a length of PVC pipe as a seal driver, but we got it done. I would love to have a concrete floored shop under a roof. Walls would even be nice.

[yukonstew]

No prying... put 1/4 ext and 8mil socket on unit seal and axle tube and turn the wheel rear top then bottom front no matter how siezed on it will come out with zero struggle the unit bearing comes out same way...power steering is your friend.

[donniephares]

Very good video is the driver side the same way

[terrellscaife]

So have you ever thought about getting the special U joint puller tool or at least a ball joint press the removal will go a lot smoother faster and efficient

[-j]

What’s the seal behind the joint you changed called
The one in video is axle shaft seal or knuckle seal
But what about smaller one behind the ujoint

[masi]

Bearing supposed to face outside to the tire

[philipcbarrera]

Could of gotten that u joint out using a u joint press instead of pounding on it with a BFH.

[wesbrackmanthercenthusiast]

I have a question is there supposed to be play in the Bering on the axle on either side of the u joint if so can that be replaced without a hydraulic press?

[l.m.]

Good luck hammering it out when it’s NOT broken.

[kennethbrown]

NOT the way to remove the old u-joint.

[BigJsgarage]

you put the grease fitting on the wrong side🤨🤨