Simulation of Compressor and Turbine in Aspen HYSYS

In this video, you will learn how to calculate adiabatic efficiency for compressor and turbine, how to find out gas discharge temperatures from a compressor also the power production from a turbine. Then we will solve a problem in HYSYS to understand these concepts.

📢 If you find my content helpful, please don't forget to subscribe to my channel 🔔. If you want ❤️ to learn Aspen HYSYS from very basic, then check the following links:

Tutorial #1

Getting started with Aspen HYSYS

Tutorial #2

Bubble point, Dew point and Phase diagram calculations

Tutorial #3

Flash calculations in HYSYS

Tutorial #4

Sensible and latent heat and generation of saturated steam table in Aspen HYSYS

Tutorial #5

Centrifugal pump sizing and selection in six easy steps

Tutorial #6

Pump power and efficiency calculations in HYSYS

Tutorial #7

Pump performance curves generation and rating in HYSYS

#CompressorDesign #TurbineEfficiency #Powerfromturbine

[chrischan]

Very good presentation. But you should also mention that 32 KW of power was required to compress from 1 bar to 10 bar and only 20 KW power was recovered by the Turbine in expanding the same gas from 10 bar to 1 bar. Where did the rest of the 12 KW power go? make the student

[AryatuhaProsper]

Thank you, Sir, for sharing such insightful information. I would like to know incase it's a liquid stream, how would it be simulated for the case of Turbine? (Liquid turbine)

[shamsaalhadhrami]

thank you sir for explaining the hysys in very easy way but if you don't mind can you give us some references so we can practice more in hysys.