🔧Tool Tech Tuesday #46 | Air Hammer Attachments | What Bits Do What

Air Hammers can do A LOT of different things. Stuck, rusted bolt? Punch it out with the air hammer. Need to cut the heads off structural rivets? Chisel them off with the air hammer. Ball joints, sheet metal work....all kinds of jobs can be made easier with an air hammer!

You can always find me here:
Instagram: @Moonbuilt
Twitter: @BuiltMoon

MoonBuilt Garage Merchandise - T-Shirts and More:

Tools Used For This Build:

What I Use To Film:

Affiliate Links:

Disclaimer: Some of these links are affiliate links where I'll earn a small commission if you make a purchase at no additional cost to you. This helps support the channel and allows us to continue to make videos like this. Thank you for the support! All opinions are my own and presented without editorial input from outside sources.

Disclaimer:
Due to factors beyond the control of MoonBuilt Garage and WJM Industries LLC, we cannot guarantee against improper use or unauthorized modifications of this information. MoonBuilt Garage and WJM Industries LLC assume no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. MoonBuilt Garage and WJM Industries LLC recommend safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of MoonBuilt Garage and WJM Industries LLC, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not MoonBuilt Garage or WJM Industries LLC.

Produced and owned by WJM Industries LLC

#moonbuiltgarage #toolreview #tools #airhammer

[Mikk-we]

That last sheet metal bit you showed, I use it to cut the lids off the 200 oil drums. Works really good and cuts it off the flange so its nice and flush, without any sharp edges. I use those drums for scrap metal.
The other thing I found out, is that you can use round shank bits on a hex shank air hammer.
And I didnt know that there is a frame that you can mount your airhammer, to use it like that. It seems like a good idea.

Thanks mate!

[fredcsensits]

Never been able to chisel anything over 1/4 inch I'd diameter

[bartimisfoul]

How do you change the fucking bit. Nobody had a video on that.