Installing camshafts into common rail Volkswagen TDI

Camshaft timing process on VW TDI common rail TDI

[neildejager]

So simple when you know. Thanks bud. You saved me lots of time and effort.

[Tyranthraxus]

Good video, and nicely explained. I appreciate the admission to the rookie mistake, however, this is all natural when going through an excercise for the first time. It helps the viewers understand the challenges of doing this job. I have seen Elsawin extract of how to do this and curious if the VW tools are really necessary as mentioned below (T40094/T40096).

[daxgree]

nice video, why do you change to arp studs? running higher boost and thinner headgasket?

[Yarusi]

Have you adjusted your valves? Would it be necessary to adjust valves on a stock head tdi with higher miles?

[colin]

Nice video very helpful and well explained thank you sir

[jonmckinney]

Great video, tons of useful information.

[DeezOlpassat]

You mention ARP stud swap after OEM bolts removed. What part# did you use??

My project— 2014 Passat CKRA-TDI, replaced head gasket after 300k miles, w/valve job. Wrong head gasket and I’m tired of single use bolts. Plus need the strength for Stage3 malone tune Ive been running for a few years.

[onedikeinoc]

Hello, I broke the bolt that holds the cylinder with the clamp. What is the name of that bolt and if it can be removed without disassembling the engine?

[brodie]

Thanks! I have a few Questions. Im about to attempt this and i have conflicting info.

[CoconutsHD]

Great video. I'm also finding that there's not a huge amount of information on these CR TDIs yet. Thanks for thinking about us☺

[zakariyakhaki]

Hi what is the nm for the cam cage bolts and the sequence ?

[HeyHiHello]

How did thqt timing trick with the cams go? Prior to pulling mine out, vac side cam was not square to head but never had any issues.

[EdwardMcClung]

Thank you so much for this!!!! Thank you!!!

[gregorylaughlin]

Thanks for this. Could you tell me where you got the stud kit?

Olá tudo bem ? Gostei do seu canal que carro é este do video ?

[stevegm]

thanks for the video. I have a ticking noise coming from my engine when it’s cold. When the the engine has a bit of temperature it’s very difficult to notice. 2.0 CFGB. Any known issues?

[dazzadj]

Are you able to tell me what the torque setting is for the cam locking plate? The big cover that locks the cams in (10mm bolts)

[amkvr]

What sealant did you use between the two surfaces?

[sergiusimplu]

How's the cp3 working? Did you have to remap according to the cp3 parameters or cancel lift pump?

[wong]

Thank you for the upload. Any chance you could let me know what the tighten torque of the camshaft cap is? Or the Girdle as is otherwise known. Please and thanks.