BTT GTR v1.0/M5 v1.0 - configuration of A4988 and DRV8825 steppers

This is a simple tutorial on how to install either or both A4988 or DRV8825 on the BTT GTR v1.0 and configure the Marlin firmware for 2.0.x.

One Time Tips, You Can PayPal Me:
Discord:
Patreon:

Hardware:
1 - BigTreeTech GTR v1.0/M5 v1.0
1 - USB Serial cable
1 - SD/TF drive with adapter
1 - A4988
1 - DRV8825

Amazon Affiliate Links:

Documentation:
Reprap calulator:

Software:
Arduino IDE:

[hobbyrob]

Hello Edward,

would you please help me with the BIGTREETECH SKR E3-DIP V1.1
I want to put A4988 / DRV8825 stepsticks in there, but I don't know how the jumpers should be
(how to stand
/how to set the jumpers)
I would also like to know more about software,
how do I set up the Marlin? for a regular Prusa i3
(only I have M5 Zas thread)

I bought that BTT but find it very difficult in retrospect!
(I might have been better with the Arduino and Ramps!)

friendly greetings from The Netherlands!
Rob

[neptarclepuffin]

love the video is much more detailed than the manual thank you

[jtbranman]

I know they have some different functions but which do you prefer, the GTR or the SKR? Is one a better value with the features versus cost?

[иванш-жч]

Hi Edward. I want to build multifunctional CNC boards based on GTR V1.0 board. how to connect and parameterize servo drives of servo42 (a, b) type or other companies to the GTR board?

[MaNwEMeLoDyAM]

I did all exactly like You said. but stepper motor do not move
I cant setup voltage at driver because is 0.00 always.
no matter how much I turn the screw
What I could done wrong?

[jim.c]

If you have tmc5160 I would love to see how you set them up.

[douletap]

once again no mention of how to set up the drivers on the actual m5 v1.0

[MaNwEMeLoDyAM]

Can You Make movie.
How to set up this motherboard a settings for XY core 3d printer?